Fabrication and Characterization of NiCoCrAlY Coating Deposited on Nickel-Based Superalloy Substrates

Xiaowei Hou,Congchun Zhang,Fei Wang,Guifu Ding
DOI: https://doi.org/10.1016/j.vacuum.2018.05.041
IF: 4
2018-01-01
Vacuum
Abstract:NiCoCrAIY coatings were prepared on GH3128 nickel-based superalloy substrates using radio-frequency magnetron sputter deposition. Scanning electron microscopy (SEM) and energy dispersive X-ray spectroscopy measurements showed different particle growth in the thin films after annealing the as-deposited coatings at various heat treatment conditions. In addition, X-ray diffraction data revealed that the annealed coatings showed in common only one main peak, which was assigned to they'-Ni3Al phase. Cross-sectional SEM analysis showed that NiCoCrAlY coating after heat treatment at 1100 degrees C in air for 3 h had five layers, including the oxide layer, outer layer, middle layer, substrate, and interdiffusion layer. Elemental line scanning confirmed that the oxide layer contained Al and O. The electrical resistance of the insulating films at high temperature was measured over the range of 400 degrees C-800 degrees C. Our results revealed that the use of non-oxidizing gas during pre-heat treatment contributed to improving the electrical insulation behavior of the films.
What problem does this paper attempt to address?