Abstract:The oxidation of bond coat (BC) and interdiffusion between BC layer and superalloys were two mechanisms that contribute to the degradation of thermal barrier coating system (TBCs). The oxidation and interdiffusion of TBCs on single-crystal superalloys were comparatively studied in this work at 950 °C, 1050 °C and 1100 °C over a duration of 1500 h. The results indicated that the thickness of the thermally grown oxide (TGO) progressively increased with the oxidation time and temperature, following a parabolic law. The discontinuous TGO gradually developed into a double-layer structure: the upper layer was a mixed oxide layer, while the lower layer predominantly comprises an Al 2 O 3 layer. Moreover, an interdiffusion zone (IDZ) is formed at the interface between the BC layer and the substrate, with its thickness increasing in response to both temperature and oxidation time. The Cr-rich phases appeared in the IDZ, where Al initially diffused from the BC layer to the substrate, followed by a reverse diffusion process. Simultaneously, Ni and refractory elements diffused from the substrate into IDZ, resulting in the precipitation of the topologically close-packed (TCP) phases and the formation of a secondary reaction zone (SRZ). It has further been shown that Cr-rich phases further diffused into SRZ. Higher oxidation temperatures accelerated the growth of the SRZ and facilitated the transformation of the TCP phases from a blocky to a needle-like morphology. Ultimately, the continuous growth of IDZ and SRZ led to the evolution of the substrate from a monocrystalline to a polycrystalline structure. This study provides valuable data on the microstructural evolution of TBCs and the assessment of their service life.

Effects of aluminised-coating on microstructure and properties of Ni–Co-base superalloys

Influences of MCrAlY Coatings and TBCs on Oxidation Behavior of a Ni-Based Single Crystal Superalloy

Effects of Ni and Cr on the high-temperature oxidation behavior and mechanisms of Co- and CoNi-base superalloys

Effect of coatings on oxidation behavior of a fourth generation Ni-based single crystal superalloys at ultra high temperature

Effect of Co distribution on the oxidation behavior of aluminide coatings in Mo-rich Ni-based single-crystal superalloy

Effects of Al content on microstructures and high-temperature tensile properties of two newly designed CoNi-base superalloys

The Effects of Alloying Elements Cr, Al, and Si on Oxidation Behaviors of Ni-Based Superalloys

The effect of amorphous coating on high temperature oxidation resistance of Ni-based single crystal superalloy

Effect of Nickel Aluminide Microcrystalline Coating on High-Temperature Oxidation Behavior of NiAl-33.5%Cr-0.5%Zr Alloy

Interdiffusion mechanism at the interface between TiAl alloy and NiCoCrAlY bond coating

Oxidation Behavior of Aluminide Coatings on Cobalt-Based Superalloys by a Vapor Phase Aluminizing Process

Comparative study of temperature-dependent oxidation and interdiffusion behavior on NiCoCrAlYHf-coated nickel-based single-crystal superalloys

High Temperature Oxidation Resistance and Degradation Mechanism of Al-Si Coatings on Nickel-Based Superalloy at 1000.

The Effect of Coating Grain Size on the Selective Oxidation Behaviour of Ni-Cr-Al Alloy

Coating-assisted deterioration mechanism of creep resistance at a nickel-based single-crystal superalloy

The effects of Ni and Al elements on microstructure and mechanical properties of low carbon CoCrMo alloy coatings

High-temperature performance of Pt-modified Ni-20Co-28Cr-10Al-0.5Y coating: Formation mechanism of Pt-rich overlayer and its effect on thermally grown oxide failure

Investigation on the tensile properties of PtAl and PtReAl coated Ni3Al-based single crystal superalloy

High temperature oxidation and interdiffusion behavior of recoated NiCoCrAlY coating on a nickel-based superalloy

Effect of Pre-Oxidation on High-Temperature Oxidation Behavior of Al-Si Coating on Nickel-Based Superalloy

Structural and High-Temperature Oxidation Performance of Al-Co-Y Co-deposited Coatings on a TiAl-Nb Alloy at Low Temperatures