High-Temperature Oxidation Behavior of a Silico-Aluminized MCrAlY Coating on a Ni-Based Superalloy

E. Hatami,S. M. M. Hadavi,D. Salehi Doolabi,M. Bahamirian
DOI: https://doi.org/10.1007/s11085-022-10109-3
IF: 2.2
2022-04-02
Oxidation of Metals
Abstract:In this research, silico-aluminide diffusion coating was applied on a conventional NiCoCrAlY coating that was deposited on Hastelloy-X superalloy via the high-velocity oxy-fuel (HVOF) thermal spraying technique. The slurry method was utilized as the diffusion coating method. Diffusion heat treatment was carried out at 1050 °C. High-temperature oxidation behavior of NiCoCrAlY/silico-aluminide coated samples was studied at 1000 °C and compared with those of conventional NiCoCrAlY coatings. The coatings were explored using X-ray diffraction (XRD) and scanning electron microscopy (SEM) analysis before and after oxidation testing. Both coatings followed parabolic kinetics. The silico-aluminide overlay coating outperformed the NiCoCrAlY coating with respective parabolic rate constants of 0.0958 and 0.1702 μm2/h. After 150 h of oxidation, the silico-aluminized overlay coating maintained a single layer of alumina, while a double-layered oxide consisting of spinel and aluminum oxide was observed in the case of conventional NiCoCrAlY coating, reflecting higher stability of the NiCoCrAlY/silico-aluminized coating.
metallurgy & metallurgical engineering
What problem does this paper attempt to address?