Abstract:The deformation behavior in polycrystalline Laser melting deposited (LMD) TA15 alloy was investigated at a temperature of 500 degrees C using advanced in-situ Secondary electron microscopy (SEM) tensile setup coupled with Electron backscatter diffraction (EBSD). The grains morphology, crystal orientation, preferred pole texture, activated slip traces, grain boundaries evolution, and strain-induced misorientation were systematically analyzed during tensile straining. It was determined that the diverse alpha-grains (crystal orientation and morphology) revealed inhomogeneous deformation under tensile loading. The overall strain was allocated by grain rotation and substructure formation. The preferred oriented (0001) pole texture maximum was increased during initial strain level. In contrast, at higher strain, the texture intensity was decreased due to the formation and relocation of the newly formed substructures. The fraction of low angle grain boundaries (LAGBs 2-10 degrees) was increased continually with increasing strain. Strain-induced dislocations within larger grains formed new LAGBs, and the increasing fraction of LAGBs was validated by Kernel average misorientation (KAM) map. The prismatic slip mode was identified as the primary active slip system at the initial deformation stage. The fraction of basal and pyramidal < a > slips increased as the strain increased, describing the opposite trend to prismatic slip. The grains rotation and strain accumulation at the grain boundaries accommodated the plastic deformation, ultimately causing boundary sliding.

Microstructure and Texture Evolution of 2024 Aluminum Alloy Sheet under Different Loading Conditions

Microstructure Evolution and Modeling of 2024 Aluminum Alloy Sheets During Hot Deformation under Different Stress States

Grain Morphology Related Microstructural Developments in Bulk Deformation of 2219 Aluminum Alloy Sheet at Elevated Temperature

Microstructural and texture evolution investigation of laser melting deposited TA15 alloy at 500?C using in-situ EBSD tensile test

Microstructure and Texture Evolutions of Aa1050 Aluminum Alloy Cold Rolled to High Strains

Study of Texture in 6016 Aluminum Alloy During Processing

Microstructural Evolution of 2026 Aluminum Alloy During Hot Compression and Subsequent Heat Treatment

A Study on the Dynamic Mechanical Behavior and Microtexture of 6082 Aluminum Alloy under Different Direction

Tensile Behavior and Microstructure Evolution of an Extruded 6082 Aluminum Alloy Sheet at High Temperatures

Flow Behavior and Microstructure Evolution of 2024 Aluminum Alloy Sheet during Hot Tension Deformation

Evolution of texture and microstructure of 2E12 aluminum alloy during cold rolling and annealing

Microstructure and properties of Al-4.8Cu-0.45Mn-0.19Cd-0.18Ti-0.17Zr-0.14V aluminum alloy extrusion bar

Large Strain Deformation and Annealing of Aluminium

Anisotropic Deformation Behavior of As-Extruded 6063-T4 Alloy under Dynamic Impact Loading

Microstructure Evolution of 6016 Aluminum Alloy During Compression at Elevated Temperatures by Hot Rolling Emulation

Mechanical Behavior and Texture Evolution of Aluminum Alloys Subjected to Strain Path Changes: Experiments and Modeling

B13-O-06Evolution of Texture in 6016 Aluminum Alloy During Processing

Texture Evolution Of 01570 Aluminum Alloy Sheet

Evolution of Microstructure and Texture During Uniaxial Compression of Cast AZ31Mg Alloy at Elevated Temperatures

Distribution Characterization of Boundary Misorientation Angle of 7050 Aluminum Alloy after High-Temperature Compression

Evolution Rule of Aluminum Alloy Textures under Plane Stress State