Abstract:The effect of varying hot rolling finishing temperature and the application of intermediate annealing on the microstructure, texture evolution, and mechanical properties—including forming, hemming, and roping properties—of Al-Mg-Si alloy sheets was systematically investigated. The hot-rolled plate with a higher rolling finishing temperature exhibits a significantly higher volume fraction of Cube texture which is readily retained and inherited to the final state microstructure. A substantial quantity of Mg2Si particles can also be observed in this plate, while the amount notably decreases at lower rolling finishing temperatures. These large quantities of Mg2Si hinder the PSN effect, subsequently encouraging Cube texture and hindering CubeND texture formation during solute solution. Following intermediate annealing, Ostwald ripening mechanism leads to finer Mg2Si particles dissolve while the coarser Mg2Si continue to grow, reducing the obstruction to the PSN effect. The T4P sheets without intermediate annealing exhibit a significant volume fraction of Goss texture. Goss texture can be effectively minimized by applying intermediate annealing process and thus almost disappears in T4P sheets that undergo intermediate annealing. Cube texture proved advantageous for hemming processes but detrimental to both formability and roping performance; thus, it should be modulated within an optimal range. On the other hand, Goss texture negatively impacted all mechanical properties and should be minimized or eliminated. Optimal comprehensive properties can be achieved by lowering the hot rolling finishing temperature and implementing a suitable intermediate annealing treatment.

B13-O-06Evolution of Texture in 6016 Aluminum Alloy During Processing

Study of Texture in 6016 Aluminum Alloy During Processing

Evolution of texture and microstructure of 2E12 aluminum alloy during cold rolling and annealing

Texture Evolution Of 01570 Aluminum Alloy Sheet

Shear Texture Gradient in Aa6061 Aluminum Alloy Processed by Accumulative Roll Bonding with High Roll Roughness

Texture Evolution in an Al-Cu-Mg Alloy During Hot Rolling

Investigation of particles on the microstructure, texture and formability of Al–Mg-Si-Zn alloy for automotive body sheet

Microstructure and Texture Evolutions of Aa1050 Aluminum Alloy Cold Rolled to High Strains

Evolution of Microstructures and Textures of High Purity Aluminium During Rolling and Annealing

Texture gradient in rough-rolled plate of aluminum alloy 3104 and its effect on annealing textures evolution after hot compression

Development of Microstructures and Texture During Cold Rolling in AA 7055 Aluminum Alloy

Micro-mechanism of Texture Evolution During Isochronal Annealing of As-Annealed Hot Rolled Al-Cu-Mg Sheet

Microstructures and properties of 6016 aluminum alloy with gradient composition

Microstructure, Mechanical Properties, and Texture Evolution of Aluminum Alloy 7005 by Accumulative Roll Bonding

Texture Evolution of Al-Mg-Li Aeronautical Alloys in In-Situ Tension

Influence of Particle Stimulated Nucleation on the Recrystallization Textures in Cold Deformed Al-alloys Part II—Modeling of Recrystallization Textures

Texture Evolution of Extruded AZ31 Magnesium Alloy Sheets

Texture evolution during multi-pass cold rolling and annealing of Ti-2Al-1.5Mn alloy

Texture Evolution in Hot-Rolled Al–Cu–Mg Sheets Using Orientation Streamline Approach and Texture Index

Effect of Accumulative Roll Bonding Process on Textural Evolution and Its Comparison with Normal Rolled AA7005 Aluminum Alloy

Evolution of the Brass Texture in an Al-Cu-Mg Alloy During Hot Rolling