Abstract:The through thickness texture gradient in accumulative roll bonding (ARB) processed materials is largely dependent on the friction between the rolls and the sheet during deformation. In this study, AA6061 aluminum alloy was pre-heated to 200 degrees C for 180 s and subjected to ARB deformation under dry conditions for up to 5 cycles using rolls with a high surface roughness. The imposition of high friction conditions during rolling resulted in a large texture gradient in the through thickness of the ARB strip. The bulk texture at the strip surface mainly comprised the Rotated Cube orientation for all cycles. The strip quarter thickness consisted of a combination of a Copper dominated b-fiber and the Rotated Cube orientation after 5 cycles. The bulk texture at the strip center evolved from a predominantly Cube orientation in the fully annealed condition to one that comprised typical fcc rolling orientation components after 1 cycle. Thereafter, a gradual increase in the volume fraction of the Rotated Cube component was seen for up to 5 cycles. As expected, the average bulk texture up to 5 cycles returned the highest volume fraction for the Rotated Cube orientation along with significantly smaller volume fractions for the ideal rolling orientations. The combination of high friction induced shear deformation and the unique alternating sandwich-type deformation pattern of ARB resulted in an increasingly uniform redistribution of shear-type orientation components across the strip thickness with increasing number of cycles. (C) 2014 Elsevier B.V. All rights reserved.

Evolution of the Brass Texture in an Al-Cu-Mg Alloy During Hot Rolling

Texture Evolution in an Al-Cu-Mg Alloy During Hot Rolling

Texture Evolution in Hot-Rolled Al–Cu–Mg Sheets Using Orientation Streamline Approach and Texture Index

Effects of dislocation slip behaviour and second-phase particles on hot rolled texture of an Al-Cu-Mg alloy with a high Cu/Mg ratio

Evolution of Goss Texture in an Al–Cu–Mg Alloy During Cold Rolling

Texture Formation under Control of S Phase Characteristic and Tensile Property of Hot-Rolling 2A12 Aluminum Alloy Improved by Brass Texture

Dynamic dissolution and texture evolution of an Al–Cu–Mg–Ag alloy during hot rolling

Evolution of the Texture, Mechanical Properties, and Microstructure of Cu-2.7Be Alloys During Hot Cross-Rolling

Enhanced Brass texture of hot-rolled Al-4Cu-1.6Mg alloy by 0.1% Zr addition

Microstructure and Mechanical Properties of Pure Copper Subjected to Skin Pass Asymmetric Rolling

Texture Evolution of Hot Rolled Al–Cu–Mg–Zr Alloy During Annealing

Micro-mechanism of Texture Evolution During Isochronal Annealing of As-Annealed Hot Rolled Al-Cu-Mg Sheet

Microstructure and Texture Evolution in Cold-Rolled and Annealed Oxygen-Free Copper Sheets

Texture Evolution of Al-Zn-Mg-Cu Aluminum Alloy Plate During Cold Rolling

Microstructure and Texture Evolution in the Cryorolled CuZr Alloy

Evolution of Microstructure, Texture, and Hardness in an Al-Cu-Mg Alloy During Annealing

Developing Alternative Texture in a 90Cu-10Zn α-Brass Alloy via Route Changes in Accumulative Roll Bonding Process

Shear Texture Gradient in Aa6061 Aluminum Alloy Processed by Accumulative Roll Bonding with High Roll Roughness

Study of Texture in 6016 Aluminum Alloy During Processing

Development of Goss Texture in Al–0.3%Cu Annealed after Heavy Rolling

Investigation of Microstructure and Texture of High Purity Copper During Cold Rolling