Abstract:The through thickness texture gradient in accumulative roll bonding (ARB) processed materials is largely dependent on the friction between the rolls and the sheet during deformation. In this study, AA6061 aluminum alloy was pre-heated to 200 degrees C for 180 s and subjected to ARB deformation under dry conditions for up to 5 cycles using rolls with a high surface roughness. The imposition of high friction conditions during rolling resulted in a large texture gradient in the through thickness of the ARB strip. The bulk texture at the strip surface mainly comprised the Rotated Cube orientation for all cycles. The strip quarter thickness consisted of a combination of a Copper dominated b-fiber and the Rotated Cube orientation after 5 cycles. The bulk texture at the strip center evolved from a predominantly Cube orientation in the fully annealed condition to one that comprised typical fcc rolling orientation components after 1 cycle. Thereafter, a gradual increase in the volume fraction of the Rotated Cube component was seen for up to 5 cycles. As expected, the average bulk texture up to 5 cycles returned the highest volume fraction for the Rotated Cube orientation along with significantly smaller volume fractions for the ideal rolling orientations. The combination of high friction induced shear deformation and the unique alternating sandwich-type deformation pattern of ARB resulted in an increasingly uniform redistribution of shear-type orientation components across the strip thickness with increasing number of cycles. (C) 2014 Elsevier B.V. All rights reserved.

A Study on the Dynamic Mechanical Behavior and Microtexture of 6082 Aluminum Alloy under Different Direction

Study of Texture in 6016 Aluminum Alloy During Processing

Anisotropic Deformation Behavior of As-Extruded 6063-T4 Alloy under Dynamic Impact Loading

Texture, Microstructure and Mechanical Properties of 6111 Aluminum Alloy Subject to Rolling Deformation

Shear Texture Gradient in Aa6061 Aluminum Alloy Processed by Accumulative Roll Bonding with High Roll Roughness

Dynamic mechanical behaviors of 6082-t6 aluminum alloy

Improved Mechanical Anisotropy and Texture Optimization of a 3xx Aluminum Alloy by Differential Temperature Rolling

Microstructure and Texture Evolution of 2024 Aluminum Alloy Sheet under Different Loading Conditions

Influence of different rolling processes on the microstructures and mechanical properties of 6016 aluminum alloy

Effects Of Rolling Process On Microstructure And Mechanical Property Of 7050 Aluminum Alloy

On the Role of Texture in Governing Fatigue Crack Propagation Behavior of 2524 Aluminum Alloy

Textures Variation of 3104 Aluminum Alloy Sheets under Different Rolling Conditions

In-Plane Anisotropy of 1545 Aluminum Alloy Sheet

Development of Microstructures and Texture During Cold Rolling in AA 7055 Aluminum Alloy

Effect of Microstructures on the Anisotropy of the Roll Casting Strip of Cold Rolled 3003 Aluminum Alloy

Mechanical Properties and Microstructural Evolution of 6082 Aluminum Alloy with Different Heat Treatment Methods

Anisotropic Behavior and Temperature-Dependent Mechanical Properties of Aa1060 Aluminum Alloy: A Comprehensive Microstructural Study

High-Temperature Tensile Mechanical Properties and Microstructure of Rolled 6082-T6 Aluminum Alloy Sheets

Effect of Accumulative Roll Bonding Process on Textural Evolution and Its Comparison with Normal Rolled AA7005 Aluminum Alloy

Effect of rolling geometry on the mechanical properties, microstructure and recrystallization texture of Al-Mg-Si alloys

Flow and Fracture Behavior of Aluminum Alloy 6082-T6 at Different Tensile Strain Rates and Triaxialities