Abstract:In order to improve the measurement accuracy of specific heat capacity under the condition of high temperature and high pressure of the heat-absorbing hydrocarbon fuel,this paper proposed an on-line measurement system for the isobaric specific heat capacity,based on the energy conservation theory of calorimeter. The system temperature measurement range is 450-900 K,and the measurement pressure can be up to 10 MPa. The calibration system was calibrated with cyclohexane and a binary mixture of n-hexane and n-heptane with mass ratio of 1∶ 1. The relative error between the experimental results and the literature was within ± 1%,and the absolute average relative error was less than 0. 32%. With this system calibrated,the isobaric specific heat of two endothermic hydrocarbon fuels with different compositions was measured at a temperature of 450-900 K and a pressure of 2. 0-5. 0 MPa. The experimental results showed that in the low-temperature range,the constant-pressure heat capacity of hydrocarbon fuel exhibits a nearly linear increase with temperature,reaching a peak at the pseudo-critical and critical temperature.The peak gradually decreases with the increase of pressure,and the corresponding temperature point is continuously moved backward. After the large specific heat zone,the specific heat capacity of the fuel in-creases rapidly with the increase of temperature.

Isobaric Specific Heat Capacities of Emulsified Kerosene at High Temperature and Pressure

Measurement of Isobaric Specific Heat of Emulsified Kerosene at Supercritical Pressure

Isobaric Specific Heat Capacity Measurement for Kerosene Rp-3 in the Near-Critical and Supercritical Regions

Novel Measurement of Isobaric Specific Heat Capacity for Kerosene Rp-3 at High Temperature and High Pressure

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Measurements of the Isobaric Heat Capacity of Pressurized Liquid Trans-1,3,3,3-tetrafluoropropene [r1234ze(e)] by Scanning Calorimetry

Measurements of Isobaric Heat Capacity of R143a and R227ea at Liquid Phase by Quasi-Steady Scanning

Design of A Flow Calorimeter for Hydrocarbon Fuel at Temperatures from (330 to 900) K and Pressures Up to 6.0 Mpa

On-line Measurement of Isobaric Specific Heat Capacity for Endothermic Hydrocarbon Fuel at High Temperature

Heat Capacity of Isobutane in Liquid Phase at Temperatures from 303 K to 413 K and Pressures Up to 12 MPa

Molar excess enthalpies of ethyl acetate+alkanols at T=298.15K, p=10.0MPa

Isobaric Molar Heat Capacities Measurement of Binary Mixtures Containing Ethyl Laurate and Ethanol at High Pressures

Isobaric Specific Heat Capacity Measurements of n-Decane at Super-Critical Pressures

Measurements of Ptx and Specific Heat Capacity Cv for (r290+r1243zf) Binary Mixtures at Temperatures from (292 to 350) K and Pressures Up to 11 MPa

Viscosity Measurement of Endothermic Fuels at Temperatures from 303 K to 673 K and Pressures Up to 5.00 MPa

Pvt Measurements Of The H-2-Co2-Ch4-Co-H2o System At 740-939 K And 18.1-34.7 Mpa With An Isochoric Apparatus And The Development Of A Virial Equation Of State

Isobaric Heat Capacities of R245fa and R236fa in Liquid Phase at Temperatures from (315 to 365) K and Pressures Up to 5.5 MPa

Excess Molar Enthalpies of Dimethyl Carbonate and (butanol Isomers and 1-Pentanol) at T = (298.15, 313.15, and 328.15) K and P = (0.1, 1.0, and 10.0) MPa

Viscosity Measurements of Endothermic Hydrocarbon Fuel from (298 to 788) K under Supercritical Pressure Conditions

Isobaric Heat Capacity Measurements of Methanol by Flow Calorimeter at Elevated Temperatures and Pressures

Isobaric Heat Capacity of [EMIM][Ac] Under High Pressure