Investigation of Anisotropy Effects on Sheet-Bulk Forming of Duplex Gear Parts

Xiaolong Sun,Xincun Zhuang,Zhen Zhao
DOI: https://doi.org/10.1016/j.ijmecsci.2018.02.050
IF: 7.3
2018-01-01
International Journal of Mechanical Sciences
Abstract:Sheet-bulk metal forming, as a new process applied bulk forming on sheet metal to obtain high-quality parts with low weight, attracts the interest of automobile industry for lightweight beneficiation. In this study, the effects of anisotropy on the bulk forming of sheets under large strain were investigated. A duplex gear part of 1060 and 6061 aluminum with several types of teeth was taken as a target part. The billets were located in three different directions during forming. The forming results obtained under stroke settings of 2.0 mm (Al1060) and 1.9 min (Al6061) were used to measure anisotropy effects. Hill's 48 model was chosen as the anisotropic model. The Lankford coefficients in the model were obtained from uniaxial tension test and cube compression test. The comparison of the data from experiments and the numerical model demonstrated that Hill's 48 model (with Lankford coefficients obtained from cube compression test) most accurately predicted the anisotropy during the sheet shearing and upsetting process. (C) 2018 Elsevier Ltd. All rights reserved.
What problem does this paper attempt to address?