Abstract:Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, Ahead of Print. Additive manufacturing (AM) methods, especially selective laser melting (SLM), have recently attracted attention because they enable the quick and easy production of complex parts that cannot be produced with traditional manufacturing methods. However, residual stresses in the fabricated components impact their mechanical characteristics and may necessitate additional heat treatments. In this study, SLM-produced Ti6Al4V parts were subjected to a stress relief treatment under argon gas at 790°C for 2 h. The microstructure, microhardness and high-temperature tribological properties were examined comparatively with the traditional casting method. Dry sliding tribological experiments were carried out at different temperatures up to 600°C to compare high-temperature performance. It has been determined that the microstructure of samples produced by casting and SLM comprised β and α phases. The casting sample had 66.02% α grains, whereas the SLM sample had 59.02% α grains. The average microhardness in the SLM sample was marginally higher than that in the casting due to the formation of martensitic α. The results showed that wear rates increased with temperature for each sample. SLM samples exhibited slightly higher wear rates at each test temperature compared to the casting sample, which is attributed to the oxidative wear mechanism. The higher percentage of oxygen in the triboxide layers in the casting sample increased the wear resistance. When examining friction coefficients, an increase in average friction coefficients was observed at a test temperature of 300°C, while a decrease was observed at a test temperature of 600°C.

A Study on Microstructure and Tribology Performance of Samples Processed by Selective Laser Melting (SLM)

Tribological behavior investigation of 316L stainless steel samples processed by selective laser melting

Study of the microstructure and wear properties of Ti-12Mo-6Zr-2Fe alloy fabricated via selective laser melting

Tribological Properties of Additive Manufactured Ti6Al4V Against Cemented Carbide under Dry Sliding Conditions

Material Characterization and Lubricating Behaviors of Porous Stainless Steel Fabricated by Selective Laser Melting

Improvement of tribological performance by micro-arc oxidation treatment on selective laser melting Ti6Al4V alloy

Analysis of microstructure, mechanical properties, wear characteristics and corrosion behavior of SLM-NiTi under different process parameters

Tribological Behavior of TiC Particles Reinforced 316Lss Composite Fabricated Using Selective Laser Melting

A tribological investigation of SLM fabricated TC4 titanium alloy with carburization pre-treatment

Study on the tribological characteristics of surface triangular textured TC4 alloy prepared by SLM technology

Wear Behavior of Selective Laser Melted 06Cr15Ni4CuMo Steel

Effect of surface oxidation on wear and tribocorrosion behavior of forged and selective laser melting-based TC4 alloys

Microstructure and Fatigue Damage of 316L Stainless Steel Manufactured by Selective Laser Melting (SLM)

High-Temperature Tribology of Selective Laser-Melted Titanium Alloys: Role of Adhesive Wear

Comparison of high-temperature friction and wear behaviours of Ti6Al4V produced by additive manufacturing and casting

Microstructure effect on sliding wear of 316L stainless steel selectively laser melted

Role of laser remelting and heat treatment in mechanical and tribological properties of selective laser melted Ti6Al4V alloy

Experimental Study of Performance of Ti-6Al-4V Femoral Implants Using Selective Laser Melting (SLM) Methodology

Porosity, Hardness, Friction and Wear Performance Analysis of H13 SLM-Formed Samples

Molecular cloning of gene sequences transcriptionally regulated by retinoic acid and dibutyryl cyclic AMP in cultured mouse teratocarcinoma cells.

Study on microstructure and tribological behavior of the selective laser melted MgZnCa alloy