Abstract:Surface charges accumulated on solid insulating materials in electrical apparatuses and electronic devices could distort the initial electric field and severely damage the insulation performance. Accurate transient surface charge measurement is critical to determine the mechanisms of charge transport and flashover occurrence, and estimate surface insulation strength under high voltage. The measurement technique based on the Pockels electro-optic effect is considered as the only approach for 2-D dynamic charge distribution behaviour so far, and it has good capability to avoid original electric field distortion caused by conventional methods featured by metal probes. This paper reviews recent progress of the non-invasive dynamic surface charge measurement systems on the Pockels technique. We focus especially on typical systems with transmitting and reflecting configurations and the frequently used fast inversion algorithms. It can be inferred that higher spatial-temporal resolution, higher signal-to-noise ratio, and better compatibility for both transparent and opaque materials are the future development trends, which greatly depend on multiple technological breakthroughs at impact-resistant electro-optic crystals, advanced high-speed photography and high-performance inversion algorithms. In addition, the recent studies on transient behaviour of surface discharge, together with the present limitation and future prospects are discussed. It is expected that more ideas will be inspired in transient surface charge measurement by the Pockels technique and other relevant electro-optic methods.

Investigation on the Transient Current Response to Potential Pulse for an Electrochemical System with High Impedence

Electro-Thermo-Mechanical Investigation On Multi-Level Interconnects In The Presence Of An Esd Pulse

Transient Electrothermal Analysis of Interconnects in the Presence of a ESD pulse

Experimental research of the influence of current intermittence on electro-osmotic effect

Ion-Selective Detection of Cations and Anions by Using Pulsed Amperometric Two-Electrode System

The Reliability of Electrochemical Noise and Current Transients Characterizing Metastable Pitting of Al–Mg–Si Microelectrodes

On The Linear Response Of A Passivated Metallic Electrode To Potential Step Perturbation

Experimental Comparison of Electroosmotic Consolidation of Wenzhou Dredged Clay Sediment Using Intermittent Current and Polarity Reversal

Nanofluidic Pulser Based on Polymer Conical Nanopores

Analytical Modeling for Transient Probe Response in Pulsed Eddy Current Testing

ANALYZING, ESTIMATING AND SUPPRESSING THE INFLUENCE OF TRANSIENT ENERGY IMPULSE ON SYNCHRONOUS MEASUREMENT

ELECTROCHEMICAL TRANSIENT MEASUREMENT CONTROLLED BY COMPUTER

Review of Surface Transient Charge Measurement on Solid Insulating Materials Via the Pockels Technique

A New Aproach for Processing Data of Transient Response to A Small Amplitude Potential Step

The Potentiostatic-Galvanostatic Transient Response Character of a Passive System with Adsorption

Measuring Electrolyte Impedance and Noise Simultaneously by Triangular Waveform Voltage and Principal Component Analysis.

Transient Response Signal Mechanism of Platinum Electrode to Uncoupled Ions Zn2+, Co2+, Ni2+

Analysis of Transient Voltage Response on a 4×4 Cm Molten Carbonate Fuel Cell by a Current Pulse Method

Method of Measuring Field Emission Current under High-Voltage Pulse

Application of transient analysis using Hilbert spectra of electrochemical noise to the identification of corrosion inhibition

Steel bar corrosion monitoring by potentiostatic pulse method