Abstract:Owing to their low cost and reduced power losses, floating bush bearings are extensively used in high-speed rotors. The advantages are mainly the result of the rotation of the bush. When shaft speed is within a low speed range, bush rotation speed increases linearly with shaft speed. However, the bush-to shaft speed ratio decreases sharply when the shaft speed reaches a certain range. The mechanism of this phenomenon is not completely clear yet, and a precise prediction method has not been established. The traditional theoretical model predicts that the speed ratio remains constant even when the shaft speed reaches the certain range. Some researchers have attempted to improve the prediction model by considering thermal effect on the assumption that a temperature increase decreases the viscosity of the inner oil film and consequently reduces the speed ratio. However, temperature rise alone is insufficient to induce that much drop of speed ratio. This paper focuses on the effect of air invasion flow in the inner oil film from the axial ends and evaluates the importance of air invasion and thermal effects. Computational fluid dynamics (CFD) modeling is adopted in this study because of its capacity to handle complicated calculation domain and calculate air-oil two-phase flow. Three series of CFD simulations with different models are conducted. These models consider the thermal effect (thermal model), the air invasion effect (air model), and the combination of the thermal and air invasion effects (hybrid model). CFD results of the different models are compared to weigh the importance of each effect. The CFD calculation indicates that a substantial amount of air invades the inner oil film when the shaft speed reaches a certain range. Speed ratio drop is not Caused by a single factor, but it is the result of the combination of the air invasion and thermal effects. Air invasion, which researchers previously ignored, plays a greater role than the thermal effect.

Study on Static Thermo-hydrodynamic Lubrication of Floating Ring Bearing

Numerical Investigation of Air–Oil–Thermal Coupling Mechanism in Floating Ring Bearings

Analysis of Fluid-Thermal Coupling in Ferrofluid Bearing Used in High Speed Machines

Lubrication and stability analysis of nonlinear rotor-bearing system

Experimental and Numerical Study of the Influence of Loading Direction on the Lubrication and Cooling of Self-Circulating Oil Bearing System Applied in Internal Gear Pumps

Influence of Rotational Speed on Oil Film Temperature of Multi-Sector Recess Hydrostatic Thrust Bearing

Investigation on the nonlinear dynamic behaviors of water-lubricated bearings considering mixed thermoelastohydrodynamic performances

Experimental and numerical investigation on thermodynamic performance of full-floating ring bearings with circumferential oil groove

Coupling analysis of tribological and dynamical behavior for a thermal turbulent fluid lubricated floating ring bearing-rotor system at ultra-high speeds

Composite thermal oil film lubrication model for hybrid journal bearings

Direct Observation of Cavitation Phenomenon and Hydrodynamic Lubrication Analysis of Textured Surfaces

Mathematical modeling for nonlinear dynamic mixed friction behaviors of novel coupled bearing lubricated with low-viscosity fluid

Investigation Of Air-Oil-Thermal Distribution In Floating Bush Bearings

A Study of A Journal Bearing Lubricated by Couple Stress Fluids Considering Thermal and Cavitation Effects

Thermohydrodynamic Analysis of Journal Bearings Lubricated with Couple Stress Fluids

Thermohydrodynamic Study on Journal Bearings Using Finite Element Analysis

Multi-Physical Field, Coupled, Mixed Lubrication Analysis of Hydraulic Reciprocating Vacuum Lip Seal

Static and Dynamic Characteristics of Aerodynamic Thrust Bearings Based on Fluid-Thermal-structural Interaction Approach

Dynamic characteristics analysis of an elliptical bearing-rotor coupled system

A Thermohydrodynamic Analysis of the Self-Lubricating Bearings Applied in Gear Pumps Using Computational Fluid Dynamics Method

Research on the Lubrication Performance of Hydrostatic Thrust Bearings Considering Dynamic Pressure Effect and Oil Film Pressure Loss