Abstract:Owing to their low cost and reduced power losses, floating bush bearings are extensively used in high-speed rotors. The advantages are mainly the result of the rotation of the bush. When shaft speed is within a low speed range, bush rotation speed increases linearly with shaft speed. However, the bush-to shaft speed ratio decreases sharply when the shaft speed reaches a certain range. The mechanism of this phenomenon is not completely clear yet, and a precise prediction method has not been established. The traditional theoretical model predicts that the speed ratio remains constant even when the shaft speed reaches the certain range. Some researchers have attempted to improve the prediction model by considering thermal effect on the assumption that a temperature increase decreases the viscosity of the inner oil film and consequently reduces the speed ratio. However, temperature rise alone is insufficient to induce that much drop of speed ratio. This paper focuses on the effect of air invasion flow in the inner oil film from the axial ends and evaluates the importance of air invasion and thermal effects. Computational fluid dynamics (CFD) modeling is adopted in this study because of its capacity to handle complicated calculation domain and calculate air-oil two-phase flow. Three series of CFD simulations with different models are conducted. These models consider the thermal effect (thermal model), the air invasion effect (air model), and the combination of the thermal and air invasion effects (hybrid model). CFD results of the different models are compared to weigh the importance of each effect. The CFD calculation indicates that a substantial amount of air invades the inner oil film when the shaft speed reaches a certain range. Speed ratio drop is not Caused by a single factor, but it is the result of the combination of the air invasion and thermal effects. Air invasion, which researchers previously ignored, plays a greater role than the thermal effect.

Influence of Rotational Speed on Oil Film Temperature of Multi-Sector Recess Hydrostatic Thrust Bearing

Emulation of Temperature Model of Oil Film Bearing

Multi-objective Optimization Design of Sliding Bearing of High-speed Centrifugal Pump Based on Lubrication Characteristics Analysis

Experimental and Numerical Study of the Influence of Loading Direction on the Lubrication and Cooling of Self-Circulating Oil Bearing System Applied in Internal Gear Pumps

Simulation and Experimental on Thermal Behavior of Hydrostatic Thrust Bearing Based on Superhydrophobic/oleophobic Surface

Lubrication and stability analysis of nonlinear rotor-bearing system

Effects of oil recess structural parameters on comprehensive tribological properties in multi-pad hydrostatic thrust bearing for CNC vertical processing equipment based on low power consumption

Analysis of Circulation Characteristics and Heat Balance of High-Speed Rolling Bearing under Oil-Air Lubrication

Numerical and Experimental Investigation on Thermohydrodynamic Performance of Turbocharger Rotor-Bearing System

Investigation Of Air-Oil-Thermal Distribution In Floating Bush Bearings

Dynamic Analysis of Turbocharger Rotor Bearing with an Integrated Three Dimensional Thermohydrodynamic Model

Experimental and Numerical Analysis of a Self-Circulating Oil Bearing System for Gear Pumps

Experimental and numerical investigation on thermodynamic performance of full-floating ring bearings with circumferential oil groove

Research on the Lubrication Performance of Hydrostatic Thrust Bearings Considering Dynamic Pressure Effect and Oil Film Pressure Loss

Numerical simulations for the fluid-thermal-structural interaction lubrication in a tilting pad thrust bearing

Effects of oil-air lubrication methods on the internal fluid flow and heat dissipation of high-speed ball bearings

Numerical Investigation of Air–Oil–Thermal Coupling Mechanism in Floating Ring Bearings

Analysis of Oil-Air Two-Phase Flow Characteristics inside a Ball Bearing with Under-Race Lubrication

Inclination angle effect of tribological performance for hydrostatic bearing having tilting oil pad under variable viscosity conditions

Numerical and experimental investigation on ball motion with oil rheology and thermal effect in high speed ball bearings

Study on the Flow Stability and Dynamic Characteristics of a Water Bearing