Abstract:A damage-coupled constitutive model has been built to predict the ratcheting effect and fatigue life of Cu-Nb micro-composite conductor under different loading conditions. The model is rate-independent and has no isotropic hardening effect according to the experiments reported in Part I. The Abdel-Karim-Ohno model (Abdel-Karim and Ohno, 2000) is improved for a better description of the ratcheting effect. Two damage factors Dt and Da are respectively defined to be related to the ratcheting strain and accumulative plastic strain. The damage factor Dt is coupled to the model to reflect the stress reduction. On the contrary, the damage factor Da is not coupled to the model but still calculated to decide the failure of the conductor. Accordingly, there are three failure criteria for different peak stress levels without considering the ratcheting strain above 5%. When the peak stress is above 758.5MPa, the failure is decided by the peak stress being equal to the tensile stress corresponding to the ratcheting strain. When the peak stress is between 650MPa and 758.5MPa, the failure is caused by the competition between the ratcheting strain and Da whose critical values are respectively 5% and 0.065. When the peak stress is below 650MPa, failure happens due to Da>0.065. As a result, the simulated ratcheting effect is more or less overestimated for some loading conditions, which leads to certain deviation between the predicted and experimental fatigue life. Nevertheless, the precision is still reasonable with the fatigue life ranging from 102 to 105 which is large enough for a further analysis of the fatigue behavior of pulsed magnets where the conductor is applied.

Multishot Analysis of a 65-T Pulsed Magnet Considering Different Failure Modes of Cu-Nb Conductor

Failure Analysis of the 100 T Pulsed Magnet at the WHMFC

Failure Analysis of a 100 Tesla Pulsed Magnet

Comprehensive analyses of buckling and stress failure of high-field pulsed magnets under biaxial Lorentz force body load

Structural Analysis of Pulsed Magnets Considering Interface Characteristics.

Fault-Tolerance Performance Analysis of a Five-Phase Permanent-Magnet Linear Synchronous Machine

Fatigue Properties of Cu–Nb Conductor Used for Pulsed Magnets at the WHMFC

Internal Buckling Analysis of High Field Pulsed Magnets

Development and Performance of 65 T Fast-cooling User Magnet with Long Service Life

Design and Test of a 30 T-100 Ms Flat-Top Magnet with a Conical Bore at the WHMFC

Finite-Element Analysis of Pulsed High-Field Magnets with Precise Thermal and Structural Calculations

Mechanical Behaviors of Polymer-Based Composite Reinforcements Within High-Field Pulsed Magnets

Design and Experiments of 65 T High Field Pulsed Magnet

Advanced Numerical Simulation of Pulsed Magnets with A Finite Element Method

Uniaxial Fatigue Behavior of Cu-Nb Micro-Composite Conductor, Part II: Modeling and Simulation

The Development of High Performance Pulsed Magnets of the Prototype Facility of WHMFC

Numerical analysis on the mechanical behavior of a 5T superconducting magnet

Analysis of Electromagnetic Thermal Coupled Field in Pulsed Magnet with Finite Element Method

Optimization of Three-coil Magnetic Field Contribution of 100 T Pulsed Magnet

Design and Analysis of Power Supplies for the First 100-T Nondestructive Magnet at the WHMFC

Analysis of Damage by Quench and Improvements in Rewinding for a 9.4-T Superconducting NMR Magnet