Abstract:The finite element (FE) model updating is a commonly used tool in civil engineering, enabling damage detection, design verification, and load capacity identification. In the FE modelupdating, acceleration responses are generally employed to determine modal properties of a structure, which are subsequently used to update the numerical model. While the acceleration-based model updating has been successful in finding better approximations of the physical systems, the boundary conditions are considered yet to be difficult to accurately estimate as the acceleration responses only correspond to the translational degree-of-freedoms (DOF).Recent advancements in the sensor technology have enabled low-cost, high-precision gyroscopes that can be adopted in the FE modelupdating to provide angular information of a structure. Especially, as the angular DOF is closely related to the rotational stiffness, gyroscopes in the FE model updating would give information of boundary conditions. This study proposes a FE modelupdating strategy based on data fusion of acceleration and angular velocity. The use of acceleration and angular velocity gives richer information than the sole use of acceleration, allowing the enhanced performance particularly in determining the boundary conditions. In this paper, a numerical simulation is presented to demonstrate the proposed FE modelupdating approach using the data fusion. A beam modelled using the Euler-Bernoulli beamelement is consideredwith various boundary conditions (i.e., simply supported, fixed supports, and in between). Optimization variables of the FE model updating are selected to be the elastic modulus and the rotational stiffness of two supports. The proposed FE modelupdating based on acceleration and angular velocityis shown to be able to more accurately identifythe boundary condition than the sole use of acceleration. Consequently, this paper verifies that data fusion of acceleration and angular velocity enhances the performance of the FE modelupdating. Graduate Research Assistant Research Assistant Professor Chair Professor 4) Assistant Professor

Sensitivity-Based Finite Element Model Updating Using Dynamic Condensation Approach

Dynamic Condensation Approach for Response-Based Finite Element Model Updating of Large-Scale Structures

Dynamic Condensation Approach to Calculation of Structural Responses and Response Sensitivities

An Enhanced Substructure-Based Response Sensitivity Method for Finite Element Model Updating of Large-Scale Structures

Nonlinear finite element model updating with a decentralized approach

Static and dynamic finite element model updating of structures based on response surface method: theory and application

Finite Element Model Updating of Bridge Structures Based on Sensitivity Analysis and Optimization Algorithm

A Study On Structural Damage Detection Method Based On Model Updating

An updating method suitable for finite element model updating of large-scakled structures

Structural Damage Identification Based on Model Updating

Research on Finite Element Model Updating Technique Based on Static Strength Test

Study on Dynamic Finite Element Model Updating of Bridge Structures Based on Ambient Excitation

A sensitivity-based nonlinear finite element model updating method for nonlinear engineering structures

SENSITIVITY-BASED FE MODEL UPDATING OF A SUSPENSION BRIDGE

A Non-Intrusive Dynamic Sensitivity-Based Substructure Model Updating Method for Nonlinear Systems

Finite Element Model Updating of Bridge Structures Based on Improved Response Surface Methods

STATIC MODEL UPDATING METHOD VIA COMPLEX DOMAIN SENSITIVITY ANALYSIS

Finite Element Model Updating using Acceleration and Angular Velocity *Hyun-jun

Substructure Based Approach to Finite Element Model Updating

Updating of Finite Element Model in Considering Mode Errors with Fuzzy Theory

Updating of Dynamic Model for Long-Span Bridges Based on Structural Sensitivity Analysis and Optimization Design Principle