Abstract:Substructure method has been widely applied in dynamic analysis of complex structures due to high computational efficiency. On the basis of Residual flexibility mixed-boundary (RFMB) substructure method, a model updating approach is proposed in this paper. Four major steps of the RFMB model updating method are summarized as: 1) Substructuring: Dividing the whole structure into residual part and reduced part according to the junction surface; 2) reduction: Using the RFMB component mode synthesis approach to reduce the order of each substructures; 3) assembly: Residual structure analysis by using the reduced assemble matrix; 4) updating: Model updating by solving the optimization problem. Numerical simulation is conducted to verify the effectiveness by adopting a cantilever plate in case I. In case II, the proposed method is applied to identify the elastic parameter of interface of a bolted joint structure using experimental data. After parameter identification, the maximum error between numerical results and the experimental data decreases to 2.44 %. And three component mode synthesis model updating methods: Craig-Bampton (CB), Mixed-boundary (MB) without considering residual flexibility and RFMB model updating approach, are applied to update the same bolted joint structure for comparing the accuracy. For comparing the computational efficiency, the RFMB model updating approach is applied to the complicated aero-engine casing structure. In case III, the average time-consuming of the Whole finite element model (WFEM) is 5.15 times to the Residual finite element model (RFEM) in the single updating iteration. Results show that the proposed approach has better performance in the finite element model updating.

A Non-Intrusive Dynamic Sensitivity-Based Substructure Model Updating Method for Nonlinear Systems

A sensitivity-based nonlinear finite element model updating method for nonlinear engineering structures

Substructure Based Approach to Finite Element Model Updating

An Enhanced Substructure-Based Response Sensitivity Method for Finite Element Model Updating of Large-Scale Structures

Model Updating with Improved Substructuring Method

Model Updating of Nonlinear Structures Using Substructuring Method

Dynamic sensitivity-based finite element model updating for nonlinear structures using time-domain responses

Substructure-based model updating using residual flexibility mixed-boundary method

Nonlinear finite element model updating with a decentralized approach

Model Updating Using Substructural Modal Data

Sensitivity-Based Finite Element Model Updating Using Dynamic Condensation Approach

Theoretical research on the energy substructure finite element model updating technology with parametric analysis

Model Updating by Combining Substructure Energy Functions and Subset Selection

A Substructuring Method For Model Updating And Damage Identification

Structural Dynamic Model Updating with Automatic Mode Identification Using Particle Swarm Optimization

A DIRECT MODEL UPDATING METHOD USING ADDED KNOWN STIFFNESS

A Two-Stage Model Updating Method for the Linear Parts of Structures with Local Nonlinearities

An updating method suitable for finite element model updating of large-scakled structures

Model Updating of Complex Structures Using the Combination of Component Mode Synthesis and Kriging Predictor

Model updating based on a substructuring method

Dynamic Model Updating Based on Strain Mode Shape and Natural Frequency Using Hybrid Pattern Search Technique