Abstract:The corrosion and electrochemical behaviour of carefully prepared ultra-lightweight magnesium-lithium (Mg-Li) alloys were investigated and compared. The alloy compositions studied were selected to provide the ability to compare unique microstructures and crystal structures, which arise from specific alloying additions of Li. Mg-4% Li is hexagonal closed-packed (HCP) alloy with Li in solid solution of Mg (alpha-Mg); Mg-14% Li is a fully solid solution BCC (beta-Li) alloy, whilst Mg-7.5% Li is a duplex (alpha-Mg thorn beta-Li) alloy. Testing in 0.1 M NaCl revealed that the corrosion performance and electrochemical response of the Mg-Li system evolved with the composition and crystallographic structure. For Mg-4% Li alloy, filiform-like corrosion morphology can be observed on the corroded surface, whilst a mixture of filiform-like corrosion to the alpha-Mg and localised dissolution of b-Li existed on the corroded surface of Mg-7.5% Li alloy. In the case of the BCC structured Mg-14% Li alloy, minor pitting was observed, concomitant with a generally low corrosion rate (particularly low corrosion rate for typical Mg alloys) and an increasing corrosion resistance with exposure time were also revealed. A combination of exposure testing inclusive of hydrogen collection and mass loss, in addition to potentiodynamic polarisation and impedance spectroscopy elucidated and quantified the corrosion performance of three differently structured Mg-Li alloys. It revealed that in spite of being composed of reactive elements of Mg and Li, the formation of beta-Li phases with BCC structure could facilitate the formation of a highly protective surface film which results in a predictable and consistently low corrosion rate of the Mg-14% Li alloy. (C) 2017 Elsevier Ltd. All rights reserved.

Composition and Microstructure Dependent Corrosion Behaviour of Mg-Li Alloys

Corrosion and Characterisation of Dual Phase Mg–Li–Ca Alloy in Hank’s Solution: the Influence of Microstructural Features

Microstructure and corrosion behavior of as-homogenized and as-extruded Mg−xLi−3Al−2Zn−0.5Y alloys (x=4, 8, 12)

Comparison on corrosion resistance and surface film of pure Mg and Mg−14Li alloy

Comparison of Microstructure, Mechanical Property, and Degradation Rate of Mg–1Li–1Ca and Mg–4Li–1Ca Alloys

Effect of Li Content on the Surface Film Formed on the Binary Mg–Li Alloys in NaCl Solution

Effect of the Al–Si eutectic on the microstructure and corrosion behavior of the single-phase Mg alloy Mg–4Li

Corrosion Resistance of Mg–8·8Li Alloy Compared with AZ91

Corrosion Mechanism of Mechanically Alloyed Mg50ni50 and Mg45cu5ni50 Alloys

Corrosion mechanism and surface protection method for magnesium-lithium alloy

Microstructure and corrosion resistance of ultrahigh pressure Mg-8Li based alloys

Corrosion Characterization of Mg–8Li Alloy in NaCl Solution

Characterisation of Li in the surface film of a corrosion resistant Mg-Li(-Al-Y-Zr) alloy

Microstructure and Corrosion Behavior of the As-cast Mg-xAl (x=9%, 12%, 15%) Alloys

Influence of Li + /Al 3+ on the corrosion behavior of Li-Al layered double hydroxides (LDHs) film on LA51 magnesium alloys

Preparation and corrosion behavior of Mg(Li)-M layered double hydroxides films on the surface of magnesium-lithium alloy

Effect of Li Content on Microstructure and Mechanical Property of Mg−xLi−3(Al−Si) Alloys

Fabricating a corrosion-protective Li2CO3/Mg(OH)2 composite film on LA141 magnesium‐lithium alloy by hydrothermal method

Research Progress on the Corrosion Behavior of Magnesium–Lithium-Based Alloys: A Review

In Vitro Corrosion of Mg–1.21Li–1.12Ca–1Y Alloy

Biodegradation of Mg-14Li alloy in simulated body fluid: A proof-of-concept study