Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Terminal Accuracy of the Feed Support System in FAST

Dynamic modeling and wind vibration control of the feed support system in FAST

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Self-Excited Vibration Analysis For The Feed Support System In Fast

Trajectory Generation and Tracking Control of A Multi-Level Hybrid Support Manipulator in Fast

EXPERIMENTAL RESEARCH OF FIRST FEED-SUPPORT SYSTEM OF FAST

Modeling of A Feed Support System for Fast

Experimental Study and Theoretic Analysis of the Structure for Supporting the Feed Cabin of the FAST

Terminal Accuracy Analysis of a Multi-level Hybrid Support System Based on Time-varying Barycenter

Similarity model of feed support system for FAST

Accuracy synthesis of a multi-level hybrid positioning mechanism for the feed support system in FAST

A Modeling Method of the Cable Driven Parallel Manipulator for FAST

Commissioning progress of the FAST

Modeling and Control Study of Cable-Driven Parallel Manipulator for FAST

Dimensional Optimization Design of the Four-Cable-Driven Parallel Manipulator in FAST

Research on longitudinal vibration characteristic of the six-cable-driven parallel manipulator in FAST

Test Study of the Feed-Support System for a Large Radio Telescope

Vibration characteristics of the feed support system in radio telescope

A Fuzzy PID Approach for the Vibration Control of the FSPM

On the Cable Car Feed Support Configuration for FAST

Study on Telescope Gain Affected by a Multilevel Hybrid Mechanism in FAST