Abstract:The ability to weld metals and insulators is widely required in aerospace, sensors and Micro-electro-mechanical systems (MEMS). Femtosecond laser welding is a precise and clean technique for bonding materials with benefits including high location accuracy, low heat-affected zone and little waste generation. However, the connection process is still unclear so that pump–probe microscopy and plasma image were used to reveal the welding mechanism at the contact interface. Under the irradiation of a femtosecond laser pulse, the aluminum melted after a few picoseconds, then re-solidified and connected two different materials. Additionally, plasma was limited in the interaction zone after laser irradiation for optical contact (OC), so the smaller affected region with the most absorbed energy was jointed easily with higher shear strength. Self-focusing and non-linear absorption in fused silica are key factors affecting the shear strength, since the energy absorption and modification in fused silica would induce internal stress and decrease the energy deposition at the contact interface. Our findings not only reduce the fracture of fused silica and increase shear strength up to 25.75 MPa by means of focal point pre-compensation, but also demonstrate the extraordinary potential of ultrashort laser welding in the field of precise connection of heterogenous materials.

Improving the Quality of Femtosecond Laser Processing Micro-Hole Array by Coated with Aluminum Film on Fused Silica Sheet

Investigation of Microhole Quality of Nickel-Based Single Crystal Superalloy Processed by Ultrafast Laser

Investigation on Geometric Precision and Surface Quality of Microholes Machined by Ultrafast Laser

High-quality Microhole Arrays by Water-Assisted Femtosecond Laser Perforating for Improved Particle Sorting

Femtosecond laser modification combined with chemical etching to achieve high-quality cutting of millimeter-thick fused silica

Self‐Organized Periodic Microholes Array Formation on Aluminum Surface Via Femtosecond Laser Ablation Induced Incubation Effect

Liquid-Assisted Femtosecond Laser Precision-Machining of Silica.

Investigation on Millijoule Femtosecond Laser Spiral Drilling of Micro-Deep Holes in Thermal Barrier Coated Alloys

Research on Laser-Assisted Micro-Milling of Fused Silica

Femtosecond Laser Processing of Fused Silica and Aluminum Based on Electron Dynamics Control by Shaping Pulse Trains

Water-assisted Femtosecond Laser Silicon Carbide Micro-hole Machining

Femtosecond Laser Processing of Arrayed Micro Holes of Metal Filtration Membrane

Ablation enhancement by defocused irradiation assisted femtosecond laser fabrication of stainless alloy

Mechanism and optimization of femtosecond laser welding fused silica and aluminum

Controlling of Surface Ablation Threshold of Fused Silica by Double-Pulsed Femtosecond Laser

Investigation on Hybrid Laser Ablation and Its Application in Fused Silica Damage Mitigation.

Processing of Micro-Hole by Millisecond Laser and Post Processing of Recast Layer

Experimental Investigation on Processing of Fused Silica Microchannels by High Repetition Rate Femtosecond Laser

Preparation of high-quality three-dimensional microstructures on polymethyl methacrylate surfaces by femtosecond laser micromachining and thermal-induced micro-leveling

Experimental Study on Femtosecond Laser-Induced Microjet-Assisted Trepan Drilling of Silicon Wafer

Improvement of Rear Damage of Thin Fused Silica by Liquid-Assisted Femtosecond Laser Cutting