Fabricating and TCAD Optimization for a SiC Trench MOSFET With Tilted P-Shielding Implantation and Integrated TJBS
Bo Yi,Huan Li,Bingke Zhang,Yi Xu,Wenkun Shi,Yong Xiang,Rong Zhou,Junji Cheng,Haimeng Huang,Moufu Kong,Hongqiang Yang
DOI: https://doi.org/10.1109/ted.2024.3361405
IF: 3.1
2024-03-06
IEEE Transactions on Electron Devices
Abstract:In this article, we proposed and fabricated a prototype of single-channel SiC trench MOSFET with integrated trench junction barrier Schottky (TJBS) on the trench side for 1200-V application, named TJBS-MOS. The TJBS is protected by the grounded shielding layers under the gate and trench bottom. The measured specific ON-resistance ( ) is 5.95 cm2, with reverse conducting ON-state voltage = 2.6 V at 300 A/cm2, which is reduced by 2.0 V compared with that of the CoolSiC MOSFET. Utilizing TCAD calibration according to the measured results, optimized results show that for the 1200-V-rated TJBS-MOS, of 2.52 cm2 with = 2.04 V at 300 A/cm2 is obtained. Due to reduced channel density, is increased by 24.8% compared to a CoolSiC MOSFET with the same design rules. Fortunately, a high-frequency figure of merit (HFFOM1: and HFFOM2: ) are improved by 57.2% and 72.9%, respectively, owing to smaller and . Combined with reduced reverse recovery charge for the unipolar TJBS, the turn-on loss ( ) and the turn-off loss ( ) at 25 °C are reduced by 32.8% and 80.7%, respectively. Moreover, under high temperatures, of the CoolSiC MOSFET increases significantly, while of the TJBS-MOS remains unchanged.
engineering, electrical & electronic,physics, applied