Abstract:A dual double interlocked storage cell(DICE)interleaving layout static random-access memory(SRAM)is designed and manufactured based on 65 nm bulk complementary metal oxide semiconductor technology. The single event upset(SEU) cross sections of this memory are obtained via heavy ion irradiation with a linear energy transfer(LET) value ranging from 1.7 to 83.4 MeV/(mg/cm 2 ). Experimental results show that the upset threshold(LET th ) of a 4 KB block is approximately 6 MeV/(mg/cm 2 ), which is much better than that of a standard unhardened SRAM with an identical technology node. A1 KB block has a higher LETthof 25 MeV/(mg/cm 2 ) owing to the use of the error detection and correction(EDAC)code. For a Ta ion irradiation test with the highest LET value(83.4 MeV/(mg/cm 2 )), the benefit of the EDAC code is reduced significantly because the multi-bit upset proportion in the SEU is increased remarkably. Compared with normal incident ions, the memory exhibits a higher SEU sensitivity in the tilt angle irradiation test. Moreover,the SEU cross section indicates a significant dependence on the data pattern. When comprehensively considering HSPICE simulation results and the sensitive area distributions of the DICE cell, it is shown that the data pattern dependence is primarily associated with the arrangement of sensitive transistor pairs in the layout. Finally, some suggestions are provided to further improve the radiation resistance of the memory. By implementing a particular design at the layout level, the SEU tolerance of the memory is improved significantly at a low area cost. Therefore, the designed 65 nm SRAM is suitable for electronic systems operating in serious radiation environments.

Pulsed-laser Testing for Single Event Effects in a Stand-Alone Resistive Random Access Memory

Research on Single Event Effect Test of a RRAM Memory and Space Flight Demonstration

Laser Microbeam Experiment on Single Event Effect in SRAM

Electrothermal Modeling and Simulation of Resistive Random Access Memory (RRAM) with Different Resistive Switching Oxides

Application of Two-Photon-Absorption Pulsed Laser for Single-Event-Effects Sensitivity Mapping Technology

SEE Sensitivity Evaluation for Commercial 16 nm SRAM-FPGA

Characterization of LDO Induced Increment of SEE Sensitivity for 22-Nm FDSOI SRAM

Single event effect experiment on SoC using pulsed laser

Single Event Effects in Commercial FRAM and Mitigation Technique Using Neutron-Induced Displacement Damage

Study on Single Event Upsets in a 28 Nm Technology Static Random Access Memory Device Based on Micro-Beam Irradiation

PULSED LASER SIMULATION OF VLSI SINGLE-EVENT EFFECT TESTING STUDY

Heavy Ion Radiation Effects on a 130-Nm COTS NVSRAM under Different Measurement Conditions

Radiation Effects on 1 Mb HfO2-based Resistive Memory

Verification of SEU Resistance in 65 Nm High-Performance SRAM with Dual DICE Interleaving and EDAC Mitigation Strategies

Electron-Induced Single-Event Effect in 28 nm SRAM-Based FPGA

Resistance Non-volatile Memory — RRAM

Characterization of Single Event Effect in a Radiation Hardened Programmable Read-Only Memory in a 130 nm Bulk CMOS Technology

Heavy-ion and Pulsed-Laser Single Event Effects in 130-Nm CMOS-based Thin/thick Gate Oxide Anti-Fuse PROMs

Programming Strategy Optimization of RRAM Fabricated by 28 nm Standard CMOS Process

Dual Ion Effect of the Lithium Silicate Resistance Random Access Memory

The Influence of Ion Track Characteristics on Single-Event Upsets and Multiple-Cell Upsets in Nanometer SRAM