Abstract:Glass ceramic (GC) is the most promising material for objective lenses for extreme ultraviolet lithography that must meet the subnanometer precision, which is characterized by low values of high spatial frequency surface roughness (HSFR). However, the HSFR of GC is typically degraded during ion beam figuring (IBF). Herein, a developed method for constructing molecular dynamics (MD) models of GC was presented, and the formation mechanisms of surface morphologies were investigated. The results indicated that the generation of the dot-like microstructure was the result of the difference in the erosion rate caused by the difference in the intrinsic properties between ceramic phases (CPs) and glass phases (GPs). Further, the difference in the microstructure of the IBF surface under different beam angles was mainly caused by the difference in the two types of sputtering. Quantum mechanical calculations showed that the presence of interstitial atoms would result in electron rearrangement and that the electron localization can lead to a reduction in CP stability. To obtain a homogeneous surface, the effects of beam parameters on the heterogeneous surface were systematically investigated based on the proposed MD model. Then, a novel ion beam modification (IBM) method was proposed and demonstrated by TEM and GIXRD. The range of ion beam smoothing parameters that could effectively converge the HSFR of the modified surface was determined through numerous experiments. Using the optimized beam parameters, an ultrathin homogeneous modified surface within 3 nm was obtained. The HSFR of GC smoothed by ion beam modification-assisted smoothing (IBMS) dropped from 0.348 to 0.090 nm, a 74% reduction. These research results offer a deeper understanding of the morphology formation mechanisms of the GC surfaces involved in ion beam processing and may point to a new approach for achieving ultrasmooth heterostructure surfaces down to the subnanometer scale.

Preferential Sputtering on Multicomponent Optical Surfaces

Modelling and Optimization for Deposition of SiO X N Y Films by Radio-Frequency Reactive Sputtering

Targets of Red Grapes: Oxidative Damage of DNA and Leukaemia Cells

Surface roughness evolution mechanism of the optical aluminum 6061 alloy during low energy Ar+ ion beam sputtering

Investigation of Roughness Evolution of Ion Sputtered Fused Silica Surface.

Surface modulation to enhance chemical mechanical polishing performance of sliced silicon carbide Si-face

Molecular Dynamic Investigation of the Anisotropic Response of Aluminum Surface by Ions Beam Sputtering

Multiscale Modeling Of Surface Sputtering In A Scanning Transmission Electron Microscope

Level set simulation of focused ion beam sputtering of a multilayer substrate

Nanopatterning of Si(110) Surface by Ion Sputtering: an Experimental and Simulation Study

Study of ion sputtering on AlxSn100-x alloy system

A Monte Carlo study of surface sputtering by dual and rotated ion beams

On the Microcrystal Structure of Sputtered Cu Films Deposited on Si(100) Surfaces: Experiment and Integrated Multiscale Simulation

Subnanoscale Ion Beam Modification-Assisted Smoothing of Heterostructure Surfaces

Mechanism of chemical and mechanical mutual promotion in photocatalysis-assisted chemical mechanical polishing for single-crystal SiC

Optical characterization and laser damage of fused silica optics after ion beam sputtering

Nanostructuring of Si(100) by Normal-Incident Ar+ Ion Sputtering at Low Ion Flux

Figuring of an ultra-smooth surface in nanoparticle colloid jet machining

Surface modeling for optical fabrication with linear ion source

On the stabilization of ion sputtered surfaces

Surface Morphology Evolution during Chemical Mechanical Polishing Based on Microscale Material Removal Modeling for Monocrystalline Silicon