Abstract:Ammonium sulfate (AS) is of interest as an additive in stationary combustion plants for the simultaneous control of NOx (through selective noncatalytic reduction, SNCR) and deposition and corrosion (through sulfation of alkali chlorides). The SNCR performance of ammonium sulfate was evaluated through experiments in a laboratory-scale flow reactor. Experiments with 5 and 10 wt % aqueous ammonium sulfate solutions, corresponding to AS/NO ratios above 1, yielded NO reductions up to 95% in a temperature interval of 1025–1075 °C. The results indicated that sulfur from ammonium sulfate is mainly released as SO3, even though SO2 is detected in increasing concentrations at temperatures above 1000 °C. Addition of KCl to the SNCR process was shown to promote the reaction at lower temperatures, extending the temperature window for reduction by 50 °C. Furthermore, ammonium sulfate facilitated a high degree of KCl sulfation at or below 1000 °C, demonstrating the potential of using ammonium sulfate to simultaneously reduce NOx and corrosion in full-scale combustion plants. The experiments were analyzed in terms of a detailed kinetic model. The SNCR experiments using ammonium sulfate were described satisfactorily by the model, although the NO reduction at the optimum was slightly underestimated. Also, the sulfation of KCl was captured well, but the promoting effect of KCl on SNCR with ammonium sulfate was greatly underestimated. Possible reasons for this discrepancy were discussed.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.energyfuels.1c01451?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.energyfuels.1c01451</a>.Droplet size measurements; additive feed quantification; experimental overview; measured temperature profiles; urea SNCR experiments; and EDX characterization of filter samples (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.1c01451/suppl_file/ef1c01451_si_001.pdf">PDF</a>)AS mechanism merged (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.1c01451/suppl_file/ef1c01451_si_002.txt">TXT</a>)Thermo all (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.1c01451/suppl_file/ef1c01451_si_003.txt">TXT</a>)This article has not yet been cited by other publications.

Analysis of Composite Sorbents for Ammonia Storage to Eliminate NOx Emission at Low Temperatures

Investigation on an Innovative Sorption System to Reduce Nitrogen Oxides of Diesel Engine by Using Carbon Nanoparticle

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

Solid–Gas Sorption System for Ammonia Storage and Delivery Driven by Engine Waste Heat for NOx Reduction of Diesel Engine

Thermal Conductivity, Permeability and Reaction Characteristic Enhancement of Ammonia Solid Sorbents: A Review

Development and testing of novel Chemisorption Composite using SrCl 2 -NEG adding with Carbon coated Ni and Al

Highly Efficient Fe-Cu/CL Catalysts Based on Low-Cost Clay Minerals for NH3-SCR of NOx at Low Temperature

Laser Raman Spectroscopic Investigation on the Conversion of Molten Urea into NH3 for the Selective Catalytic Reduction of NOx in Oxygen-Rich Exhaust Gases

Experimental Study on the Denitrification Performance of Calcium-based Sorbent of Mid-temperature Dry Method

Low-temperature SCR of NOx by NH3 over MnOx/SAPO-34 prepared by two different methods: a comparative study

Experimental investigation on the characteristics of ammonia storage for heavy-duty diesel engine SCR catalyst

Selective Noncatalytic Reduction of NO x Using Ammonium Sulfate

Simultaneous Removal of SO2 and NOx by Calcium-Based Sorbent with NH3 Injection at Moderate Temperatures

Recent advance for NOx removal with carbonaceous material for low-temperature NH3-SCR reaction

NO Removal by Plasma-Enhanced NH3-SCR Using Methane As an Assistant Reduction Agent at Low Temperature

Tuning the Standard SCR Reaction Kinetics to Model NO Conversion in a Diesel Engine Exhaust SCR Catalyst System Under Steady State Conditions in 1D and 3D Geometries Using Ammonia Gas as the Reductant

Role of Absorber and Desorber Units and Operational Conditions for N-nitrosamine Formation During Amine-Based Carbon Capture

The Latest Research Progress of NH3-SCR in the SO2 Resistance of the Catalyst in Low Temperatures for Selective Catalytic Reduction of NOx

Excellent low temperature NH3-SCR and NH3-SCO performance over Ag-Mn/Ce-Ti catalyst: Evaluation and characterization

Review on Selective Catalytic Reduction Technology of Diesel Engines

CFD-based investigation of NO x removal from industrial waste gas by selective catalytic reduction (SCR) and selective non-catalytic reduction (SNCR) process using NH 3