Abstract:In recent years, failings of girders due to overturning in continuous girder bridges have repeatedly occurred in China. To investigate the overturning collapse mechanism and also to evaluate the rationality of anti-overturning design method using beam element models that are commonly adopted in practical design, detailed 3D finite solid element models of a typical single-column pier three-span continuous box girder bridge were built and a full-range numerical analysis of the models was conducted. The solid models included the prestressing effect and diaphragms. Both boundary and geometric nonlinearities were taken into consideration. Bearings were modeled considering the actual construction and dimensions of pot rubber bearings, the material characteristics and boundary conditions of rubber pads, and the contact properties between each part of the bearings. The analysis results revealed that the behavior of the bridge approached the nonlinear state at the onset of first bearing disengagement; the rotation (overturning) mechanism of the girder was gradually transitioned from deformable-body rotation to rigid-body rotation; all the end and middle bearings had been disengaged totally or locally at ultimate overturning failure. The analysis results also showed that bearing disengagements would lead to the ineffectiveness of the constraint in the transverse direction, which significantly reduced the overturning ultimate load and structural ductility before the final collapse. Prior to the first bearing disengagement, the vertical reactions calculated from the beam model were in good agreement with those from the solid model, while the transverse reactions were not. The behaviors were inaccurate after bearing disengagement in the beam models in which the movement of the rotation axis and transition of rotation mechanism failed to be realized. Reliable transverse stoppers and tensile anchors at bearing sections were recommended to efficiently improve anti-overturning stability and ductility in practical design.

Overturning-Collapse Modeling and Safety Assessment for Bridges Supported by Single-Column Piers

A Parametric Investigation on Ultra-low Cycle Fatigue Damage of Steel Bridge Piers under Horizontal Bi-directional Seismic Excitations

A Multi-Level Structural Assessment Strategy for Reinforced Concrete Bridge Deck Slabs

Study on Ultra‐low Cycle Fatigue Fracture of Thick‐walled Steel Bridge Piers

Collapse Mechanism and Full-Range Analysis of Overturning Failure of Continuous Girder Bridges

Failure Analysis for Overall Overturning of Concrete Single-Column Pier Bridges Induced by Temperature and Overloaded Vehicles

Analysis of Support Abutments of Curved Bridges with Single-pedestal Piers

Progressive Collapses Simulation And Importance Assessment Of Stone Arch Bridge

Overload-Induced Progressive Collapse Simulation For A Reinforced Concrete Arch Bridge

Progressive-Collapse Simulation And Critical Region Identification Of A Stone Arch Bridge

Rapid Assessment Method of Buckling Stability of Bridge Pier–Cap–Pile System Under Scour Effect

Seismic performance analysis of concrete-filled steel tubular single pylon cable-stayed bridge with swivel construction

Structural condition assessment of a bridge pier: A case study using experimental modal analysis and finite element model updating

Dynamic performance and damage evaluation of a scoured double-pylon cable-stayed bridge under ship impact

Progressive Collapse Simulation and Components Importance Evaluation of a Stone Arch Bridge

Collapse Prognosis of a Long‐span Cable‐stayed Bridge Based on Shake Table Test and Nonlinear Model Updating

A numerical analysis of inclination and rectification of ramp-bridge piers adjacent to surcharge load in soft clay area

Collapse Analysis of a Two-Span Reinforced Concrete Bridge Model

Nonlinear Stability Analysis of a Composite Girder Cable-Stayed Bridge with Three Pylons during Construction

A generalized, model-free framework for assessing scour-induced bridge pier instability