Abstract:Microstrip three-way (that is, 4.8 dB) integrated filtering power divider (FPD) is presented in this paper. The proposed FPD evenly distributes an input power signal into three equal output signals. The design incorporates balanced signal power division, and filtering technology for the removal of unwanted frequency elements and aimed at enhancing signal quality and efficiency in the radiofrequency (RF) front-end of communication systems. Microstrip folded-arms square open-loop resonator (FASOLR) is employed in the design implementation to achieve compact size. The proposed FPD features a 2.6 GHz centre frequency, with a 0.03 fractional bandwidth. The implementation is carried out on Rogers RT/Duroid 6010LM substrate with a dielectric constant of 10.7, a thickness of 1.27 mm and a loss tangent of 0.0023. The good agreement between the theoretical and practical results verifies the effectiveness of the FPD in delivering equal power outputs at the three output ports, and at the same time filtering out unwanted frequencies. The practical results of the prototype FPD indicate a good return loss of better than 15.5 dB and an insertion loss of better than 4.77+0.34 dB. The design prototype achieved compact size of 0.31 {\lambda}g x 0.18 {\lambda}g. {\lambda}g is the guided wavelength for the microstrip line impedance at the centre frequency of the 3-way equal filtering power divider.

A Compact Balanced-to-Balanced Filtering Gysel Power Divider Using $\lambda _{g}$ /2 Resonators and Short-Stub-Loaded Resonator

Filtering Power Divider with Good Output Balance and Unsymmetrical Structure

A Compact Gysel Power Divider with Unequal Power-Dividing Ratio Using One Resistor

Balanced-to-unbalanced Filtering Power Divider with Compact Size and High Common-Mode Suppression

Compact Dual-Band Balanced-to-Unbalanced Filtering Power Divider Design With Extended \textCommon-Mode Suppression Bandwidth

A Novel Compact Gysel Power Divider with Bandpass Filtering Responses

Balanced-to-Balanced Gysel Filtering Power Divider with Arbitrary Power Division

Compact 4.0–5.1 GHz Filtering Power Divider with Low Insertion Loss and Wide Stopband Using RC-Loaded Coupled SIDGS Resonators

Wideband filtering power divider based on D-CRLH resonator

Dual-Band Filtering Power Divider Using Dual-Resonance Resonators with Ultrawide Stopband and Good Isolation

Design of Compact Wideband Filtering Power Divider with Extended Isolation and Rejection Bandwidth

A Dual-Band Balanced-To-Balanced Power Divider With High Selectivity And Wide Stopband

Packaged Filtering Power Divider with High Selectivity, Extended Stopband and Wideband Isolation

Compact SIDGS Filtering Power Divider with Three-Port 10-Ghz Reflectionless Range

Compact Quadruple-Mode FSIW Filtering Power Divider With High Isolation Using Embedded Capacitive Isolation Network

A New Wideband Filtering Power Divider Based on Rectangle Patch Resonator with Compact Size

A 3.4–7.4-Ghz Filtering Power Divider with Wide Stopband and Low Radiation Loss Using Triple-Mode Hybrid Microstrip/SIDGS Resonator

Design of Filtering Power Divider with High Frequency Selectivity

High Selectivity Filtering Power Divider Based on SAW Resonator

3-way equal filtering power divider using compact folded-arms square open-Loop resonator

Millimeter Wave Dual Wideband Filtering Power Divider Using Groove Gap Waveguide and Spoof Surface Plasmon Polariton