Optimization of spray coating for the fabrication of sequentially deposited planar perovskite solar cells

Mehran Habibi,Mohammad-Reza Ahmadian-Yazdi,Morteza Eslamian

DOI: https://doi.org/10.1117/1.JPE.7.022003

2017-01-01

Journal of Photonics for Energy

Abstract:We use facile coating techniques including spray coating and drop casting to fabricate methylammonium lead iodide perovskite solar cells through a two-step sequential deposition approach. In the first step, for the deposition of the lead iodide, spray coating substitutes for the commonly used lab-scale spin coating, while the operating parameters of the former process are optimized to achieve a fully covered and uniform film of lead iodide. In the second step, to deposit methylammonium iodide atop the lead iodide layer to form methylammonium lead iodide perovskite, dip-coating process is replaced by the touch-free drop casting and scalable pulsed-spray coating. It is found that the performance of the perovskite films and devices made by pulsed-spray coating and drop casting is similar to those prepared by dip coating, while the large-scale production capabilities of such methods beside the low material consumptions of drop casting prove their potential to replace dip coating in large-scale manufacturing of perovskite solar cells. The champion devices fabricated by spray-drop and spin-drop techniques demonstrated power conversion efficiencies of 6.92% and 9.48%, respectively. It is expected that device fabrication in a low-humidity environment using the optimized parameters and optimization of other layers will result in higher efficiencies. (C) The Authors. Published by SPIE under a Creative Commons Attribution 3.0 Unported License.