Abstract:In this research, the electrochemical properties of a stir cast Al-0.65Mg-0.15Sn-0.05Ga (wt.%) alloy as an anode material in 3 wt.% NaCl solution was examined by potentiodynamic polarization and electrochemical impedance spectroscopy (EIS). The corrosion behavior of the material was also evaluated using self-corrosion rate, hydrogen evolution, open circuit and closed circuit potentials, and anode efficiency measurements. In addition, the microstructure of the material was studied using scanning electron microscopy (SEM) and the intermetallic particles were analyzed by energy dispersive spectrometer (EDS). The results showed that tin inclusions were formed within the grains and along the grain boundaries and the dissolution of aluminum substrate was occurred preferentially around these particles leading to form round pits. The dissolution of alloy was accompanied by hydrogen gas evolution from cathodic tin particles. Polarization measurements showed active behavior with considerably negative corrosion potential value without any passive region. The obtained impedance results showed an increase in the impedance values due to the coverage of anode surface by reaction products during immersion. A sample of the alloy which was subjected to homogenizing annealing at 570 °C showed more active behavior by providing more negative open and closed circuit potential values and improved anode efficiencies at higher impressed currents, but evolved higher amounts of hydrogen compared to the as-cast anode.Graphical abstractThis paper aims at evaluating the electrochemical and microstructural characteristics of an as-cast and solution-annealed Al-0.65Mg-0.15Sn-0.05Ga alloy anode which was fabricated by stir casting. The polarization and EIS results indicate negative corrosion potential and OCP values without passive region. The activity and anodic efficiency of the solution-annealed anode was higher in high impressed current densities but evolves more hydrogen

SVET Study of Galvanic Corrosion of Al/Mg2Si Couple in Aqueous Solutions at Different Ph

SVET and SIET Study of Galvanic Corrosion of Al/MgZn2in Aqueous Solutions at Different Ph

SVET and ToF-SIMS Studies on the Galvanic Corrosion of Β-Phase/aluminum Couple in Aqueous Solutions As a Function of Ph

Understanding the Galvanic Corrosion of the Q-phase/Al Couple Using SVET and SIET

Corrosion Mechanism Associated with Mg2Si and Si Particles in Al–Mg–Si Alloys

Simulating Corrosion of Al2cumg Phase by Measuring Ionic Currents, Chloride Concentration and Ph

Microgalvanic Corrosion of Mg–Ca and Mg–Al–Ca Alloys in NaCl and Na2SO4 Solutions

Initial micro-galvanic corrosion behavior between Mg2Ca and α-Mg via quasi-in situ SEM approach and first-principles calculation

Corrosion Behavior of Pure Mg Based on Generation/Collection and Feedback Modes of Scanning Electrochemical Microscopy

Electrochemical and microstructural investigations on an as-cast and solution-annealed Al–Mg–Sn–Ga alloy as anode material in sodium chloride solution

Comparative, Real-Time in Situ Monitoring of Galvanic Corrosion in Mg-Mg2Ca and Mg-MgZn2 Couples in Hank's Solution

Influence of Si contents on the microstructure and corrosion resistance of the Zn−Al−Mg−Si alloys

Electrochemical corrosion performance of Si-doped Al-based automotive alloy in 0.1 M NaCl solution

In-situ AFM and quasi-in-situ studies for localized corrosion in Mg-9Al-1Fe-(Gd) alloys under 3.5 wt.% NaCl environment

Microstructure and Corrosion Resistance of Solidified Zn-Al-Mg Alloys

Composition and Microstructure Dependent Corrosion Behaviour of Mg-Li Alloys

Effect of the Al–Si eutectic on the microstructure and corrosion behavior of the single-phase Mg alloy Mg–4Li

Electrochemical, TOF-SIMS and XPS Studies on the Corrosion Behavior of Q-phase in NaCl Solutions As a Function of Ph

Corrosion Characterization of Mg–8Li Alloy in NaCl Solution

On the effect of trace Si on accelerating the corrosion of Mg-Mn alloys

Insight into the Corrosion Inhibition Mechanism of Sodium Silicate on the Magnesium Alloy Surface: Experimental and Theoretical Calculations