Abstract:Low-frequency vibration induced by the complex internal flow of centrifugal pumps has been a long-standing challenge in the design of low-vibration pumps. In this paper, a theoretical method of blade thickness calculation is proposed for the passive control of complex flow in centrifugal impellers, and the effects of blade modification based on secondary flow suppression on the dynamic characteristics of model pump are studied by both experimental tests and numerical simulations. The experimental results show that pressure pulsations are affected by flow rate, and their amplitude at the blade passing frequency (fBPF) dominates and increases at partial load conditions. The redesigned impeller improves the dynamic performance of the model pump considering the relatively lower pressure amplitude at fBPF and the vibration level at lowfrequency band under almost all concerned flow rates. Based on steady-state numerical results, the visualization and quantitative analysis of impeller outflow by introducing the secondary flow coefficient and the static pressure energy coefficient can reveal the correlation between secondary flow suppression and dynamic performance improvement. The proposed blade modification can effectively inhibit the development of secondary flow in the boundary layers and improve the uniformity of static pressure energy distribution of impeller outflow, which results in the reduction of pressure pulsation amplitude at fBPF and subsequent decrease in the low-frequency band vibration level. Meanwhile, pump operation under partial load conditions will intensify the secondary flow in the boundary layers, which contributes to a more non-uniform energy distribution of impeller outflow and deteriorates the dynamic performance of the model pump.

Analysis of Ejection-Cooling at the Shut-off Operating Condition for a Reheat Fuel Centrifugal Pump

Analysis of Inter-blade Vortex and Runner Blades Force of Pump Turbine during Load Rejection Period

Cooling Design of an Aero-Engine Fuel Centrifugal Pump at Shut-off

Performance Analysis of a Novel Hybrid Vapor Injection Cycle with Subcooler and Flash Tank for Air-Source Heat Pumps

Analysis of Pressure Pulsation Induced by Rotor-Stator Interaction in Nuclear Reactor Coolant Pump

High Efficiency and Low Pressure Fluctuation Redesign of A Centrifugal Pump Based on Unsteady Cfd Analyses

Computational Fluid Dynamics-Based Pump Redesign to Improve Efficiency and Decrease Unsteady Radial Forces

Churning Losses Analysis on the Thermal-Hydraulic Model of a High-Speed Electro-Hydrostatic Actuator Pump

Study on the Characteristics of the Nuclear Reactor Coolant Pump During the Process-Divided Start-Up Period

Effect of Suction and Discharge Conditions on the Unsteady Flow Phenomena of Axial-Flow Reactor Coolant Pump

Blade Redesign Based on Secondary Flow Suppression to Improve Energy Efficiency of a Centrifugal Pump

Research of Modal Analysis for Impeller of Reactor Coolant Pump

Hydraulic Optimization and Loss Analyses of a Low Specific-Speed Centrifugal Pump with Variable-Thickness Blades

Thermodynamic Analysis of Ejector Cooling Cycles with Heat-Driven Feed Pumping Devices

Study on the Four-Quadrant Homologous Characteristic and Two-Phase Flow Head Degradation of a Reactor Coolant Pump

Analysis of Cavitation Characteristics of High Temperature Fuel Piston Pump in the Process of Suction and Discharge

Energetic and Exergetic Analyses of Ejector Cooling Cycle with Feed Pump Driven by Expander.

Unsteady Flow Numerical Simulations on Internal Energy Dissipation for a Low-Head Centrifugal Pump at Part-Load Operating Conditions

Comparative Numerical Studies for the Flow Energy Dissipation Features in a Pump-Turbine in Pump Mode and Turbine Mode

Analysis of Cavitation Behaviour in A Centrifugal Pump

Energy loss analysis of transition simulation for a prototype reversible pump turbine during load rejection process