Abstract:Cavitation is a classic gas–liquid two-phase flow phenomenon that needs to be restricted for the hydraulic performance enhancement of centrifugal pumps. However, due to the particularity of fuel mediums and rigorous aviation conditions, the characteristics of cavitation occurring in aircraft centrifugal fuel pumps have not been elaborated. In this research, cavitation characteristics in an aircraft centrifugal fuel pump with a high rotational speed of 14,000 rpm were investigated by considering the influence of the flow rate ranging from 0.2Q d to 1.2Q d and the fuel temperature ranging from 20 °C to 100 °C. An experiment for testing the hydraulic performance of an aircraft centrifugal fuel pump was built, and a corresponding numerical simulation of gas–liquid two-phase flow was employed. The distributions of the pressure, streamlines, and turbulence kinetic energy in the centrifugal pump for different flow rates and fuel temperatures were comparatively analyzed. The net positive suction head available (NPSHa) was defined to represent the cavitation degree, and the net positive suction head required (NPSHr) was introduced to characterize the critical cavitation occurrence. It was also found that a large area of cavitation bubbles was generated in the inducer and that this area grew to block the flow channel of the impeller when the NPSHa was close to or lower than the NPSHr, which was the cavitation mechanism of hydraulic performance degradation. Additionally, the developments of the NPSHr with the flow rate and fuel temperature were determined adequately using natural exponential curve fitting. It was deduced that the occurrence of cavitation was more sensitive to higher flow rates, especially when the flow rate was higher than the designed flow rate. The effect of fuel temperature variations should also be considered for the long-time high-speed operation of centrifugal fuel pumps in the aerospace industry.

Analysis of Cavitation Characteristics of High Temperature Fuel Piston Pump in the Process of Suction and Discharge

Flow characteristics simulation and low-noise design of fuel piston pump

Optimization of the Outlet Unloading Structure to Prevent Gaseous Cavitation in a High-Pressure Axial Piston Pump

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

The CFD Analysis of Cavitation Erosion and Structural Optimization for an Unloading Valve

Investigation of cavitation characteristics in an aircraft centrifugal fuel pump

Cavitation in a high-speed aviation axial piston pump over a wide range of fluid temperatures

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

Investigation into the Effects of the Variable Displacement Mechanism on Swash Plate Oscillation in High-Speed Piston Pumps

Design Method of Water Jet Pump Towards High Cavitation Performances

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Analysis of the Flow Dynamics Characteristics of an Axial Piston Pump Based on the Computational Fluid Dynamics Method

Valve Plate Structural Optimal Design and Flow Field Analysis for the Aviation Bidirectional Three-Port Piston Pump

Study on the Cavitation Suppression Mechanism of Axial Piston Pump

Centrifugal Effects on Cavitation in the Cylinder Chambers for High-Speed Axial Piston Pumps

Modeling and Characteristic Analysis of a Cylinder Block/Valve Plate Interface Oil Film Model for 35 MPa Aviation Piston Pumps

Study of the Cavitation Phenomenon Inside Roller Vane Pump

An Investigation into the Swash Plate Vibration and Pressure Pulsation of Piston Pumps Based on Full Fluid-Structure Interactions

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

Noise Reduction of an Axial Piston Pump by Valve Plate Optimization

Research on Multi-Objective Optimization of Low Pulsation Unloading Damping Groove of Axial Piston Pump