Abstract:According to the operation parameters and the design experience parameters, a liquid hydrogen centrifugal pump was developed and tested to meet an application requirement of small flow and high head in cryogenic systems or cryogenic storage tanks. The test results showed that 6 m of hydraulic loss in the pump at the rated condition and the inlet pressure of the cryogenic fluid decreased and fluctuated, which resulted in the pump being prone to cavitation . To improve cavitation resistance and hydraulic efficiency of liquid hydrogen centrifugal pumps, the model was optimized based on the genetic algorithm of MATLAB applying 7 parameters of impeller taken as optimization variables, each sub-objective function was given corresponding weights, and the optimal solution combination at the minimum of the objective function was finally obtained, and an inducer was matched. The results showed that by reducing the angle of the inlet, increasing the diameter of the impeller, and adding an inducer, the cavitation performance of the pump can be improved and the hydraulic loss can be reduced by appropriately reducing the impeller outlet diameter, to improve the head of the pump. A comparison of the performance of the preposition inducer optimized pump with the preliminary pump shows that, at the rated condition point, the head was increased by 4.6 m resulting in an efficiency of 43%. A numerical calculation considered the thermodynamic effect of non-isothermal cryogenic cavitation on the Reynolds-averaged Navier-Stokes combined with the k - ε turbulence model was applied for getting the pump hydrodynamic performances. It was proved that the multi-objective optimization method and preposition inducers were effective, and the calculating results were by experimental data well. Feasibility of the model had been validated to a certain extent. It can bring a high level of pump optimization, integration, and quality to new and existing designs.

Cooling Design of an Aero-Engine Fuel Centrifugal Pump at Shut-off

Analysis of Ejection-Cooling at the Shut-off Operating Condition for a Reheat Fuel Centrifugal Pump

Blade Redesign Based on Secondary Flow Suppression to Improve Energy Efficiency of a Centrifugal Pump

Computational Fluid Dynamics-Based Pump Redesign to Improve Efficiency and Decrease Unsteady Radial Forces

High Efficiency and Low Pressure Fluctuation Redesign of A Centrifugal Pump Based on Unsteady Cfd Analyses

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Hydraulic Optimization and Loss Analyses of a Low Specific-Speed Centrifugal Pump with Variable-Thickness Blades

Optimization of a Centrifugal Pump to Improve Hydraulic Efficiency and Reduce Hydro-Induced Vibration

Investigation of cavitation characteristics in an aircraft centrifugal fuel pump

Blade Thickness Redesign to Improve Efficiency and Decrease Unsteady Pressure Pulsation of a Low Specific Speed Centrifugal Pump

Large Eddy Simulations of Heat Transfer and Thermal Oxidative Coking of Aviation Kerosene in Vertical U-Tube at a Supercritical Pressure

Optimization of a Centrifugal Impeller on Blade Thickness Distribution to Reduce Hydro-Induced Vibration

The Optimization of A Low Specific Speed Pipeline Pump

Optimization of the Outlet Unloading Structure to Prevent Gaseous Cavitation in a High-Pressure Axial Piston Pump

Experimental study on the internal temperature rise of a high-speed canned motor pump for liquid rocket engines

Multi-Point Optimization on the Diffuser of an Axial Flow Pump

Liquid hydrogen centrifugal pump optimization based on reducing hydraulic loss and improving cavitation

Analysis of Cavitation Characteristics of High Temperature Fuel Piston Pump in the Process of Suction and Discharge

Hydraulic performance prediction and optimization of an engine cooling water pump using computational fluid dynamic analysis

Numerical calculation and optimization designs in engine cooling water pump

Coupled Aerothermodynamics Optimization for the Cooling System of a Turbine Vane