Abstract:The transient process of a centrifugal pump existed in a variety of occasions. There were a lot of researches in the external characteristic in startup process and stopping process, but internal characteristics were less observed and studied. Study of the internal flow field had significant meanings. The performance of a pump could be evaluated and improved by revealing the flow field. In the other hand, the prediction of external characteristic was based on the correct analysis of the internal flow. In this paper, theoretical method and numerical simulation were used to study the internal characteristic of a centrifugal pump. The theoretical study showed that the relative flow in an impeller was composed of homogeneous flow and axial vortex flow. The vortex intensity was mainly determined by angular velocity of impeller, flow channel width and blade curvature. In order to get the internal flow field and observe the evolution of transient internal flow in the impeller, Computational Fluid Dynamics(CFD) were used to study the three-dimensional unsteady incompressible viscous flows in a centrifugal pump during starting period. The Dynamic Mesh (DM) method with non-conformal grid boundaries was applied to get the external characteristic and internal flow field. The simulate model included three pumps with different blade numbers and the same blade curvature. The relative velocity vector showed that there was a big axial vortex in impeller channel. At the beginning, the vortex was raised in the pressure side of the impeller outlet and with time went on, it shifted to the middle flow channel of the impeller and the vortex intensity increased. When the speed and flow rate reached a definite value, the influence of the axial vortex began to get smaller. The vortex developed faster when the flow channel got narrower. Due to the evolution of axial vortex, the slip factor during starting period was smaller than that in quasi-steady condition. As a result, transient head was lower than quasi-steady head in startup process.

Study on the Characteristics of the Nuclear Reactor Coolant Pump During the Process-Divided Start-Up Period

Analysis of Pressure Pulsation Induced by Rotor-Stator Interaction in Nuclear Reactor Coolant Pump

Analysis of reactor coolant pump transient performance in primary coolant system during start-up period

Optimization of Start-up Process in Combined Cycle Steam Turbine of a Power Plant

Effect of Suction and Discharge Conditions on the Unsteady Flow Phenomena of Axial-Flow Reactor Coolant Pump

Pressure pulsation analysis of runner and draft tube of pump turbine under different working conditions

Flow Transient In Primary Coolant System During Reactor Coolant Pump Start-Up Period

Inception behavior of the cavitation in nuclear reactor cooling pump

Transient Internal Characteristic Study of a Centrifugal Pump During Startup Process

Experimental Study on PIV Measurement and CFD Investigation of the Internal Flow Characteristics in a Reactor Coolant Pump

Research on the Transient Hydraulic Characteristics of Multistage Centrifugal Pump During Start-Up Process

Numerical and field experimental study on the start-up process of a prototype axial-flow pump system considering the motion characteristics of cutoff facilities

Study on the Four-Quadrant Homologous Characteristic and Two-Phase Flow Head Degradation of a Reactor Coolant Pump

Head-Cover Vibration Investigation of a Prototype Reversible Pump-Turbine Unit During Start-up in Pump Mode. Part I: Fluid Dynamic Analysis

Research of Modal Analysis for Impeller of Reactor Coolant Pump

Flow-Induced Vibration of Non-Rotating Structures of a High-Head Pump-Turbine during Start-Up in Turbine Mode

Stress Analysis of the Canned Nuclear Coolant Pump Based on FSI

Study on Internal Flow Characteristics and Pressure Pulsation Features of Pump-Turbine under the No-Load Startup Condition with Different Heads

Influence of Non-Uniform Inflow on Performance of Reactor Coolant Pump and Improved Design

Investigation of Unsteady Pressure Pulsations of Reactor Coolant Pump Passage under Flow Coast-down

Analysis of jet device transient feature during start-up period of primary pump