Abstract:The rapid flow transient calculation in reactor coolant pump system is important in the safety analysis of a nuclear reactor. An accurate transient analysis of flow coastdown is also important and necessary for the design and manufacture of a reactor coolant pump. Only under the reliable work of a reactor coolant pump the safety of a nuclear power plant can be guaranteed. A mathematical model is developed for solving flow rate transient and pump speed transient during flow coastdown period. The detailed information of the centrifugal pump characteristics is not required. The flow rate and pump speed are solved analytically. The analytic solution of non-dimensional flow rate indicates that non-dimensional flow rate is determined by energy ratio β. The kinetic energy of the loop coolant fluid and the kinetic energy stored in the rotating parts are two important parameters in form of β. When the steady-state flow rate and pump speed are constant, the inertia of primary loop fluid and the pump moment of inertia are also two important parameters in flow transient analysis. For the condition all pump shafts are seized, the flow decay depends on the inertia of primary loop fluid. For the case that pump inertia is very large, the flow decay is determined by the pump inertia. The calculated non-dimensional flow rate and non-dimensional pump speed using the model are compared with published experimental data of two nuclear power plants and a reactor model test on flow coastdown transients. The comparison results show a good agreement. As the flow rate approaches to zero, the increase difference between experimental and calculated value is due to the effect of the mechanical friction loss.

Inception behavior of the cavitation in nuclear reactor cooling pump

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

Analysis of Pressure Pulsation Induced by Rotor-Stator Interaction in Nuclear Reactor Coolant Pump

Study on the Characteristics of the Nuclear Reactor Coolant Pump During the Process-Divided Start-Up Period

A cavitation performance prediction method for pumps PART3 feasible for axial-flow reactor coolant pump

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Effect of Suction and Discharge Conditions on the Unsteady Flow Phenomena of Axial-Flow Reactor Coolant Pump

Dynamic Behaviors of Blade Cavitation in a Water Jet Pump with Inlet Guide Vanes: Effects of Inflow Non-Uniformity and Unsteadiness

Influence of the Impeller/Guide Vane Clearance Ratio on the Performances of a Nuclear Reactor Coolant Pump

Experimental Study on PIV Measurement and CFD Investigation of the Internal Flow Characteristics in a Reactor Coolant Pump

Study on the Four-Quadrant Homologous Characteristic and Two-Phase Flow Head Degradation of a Reactor Coolant Pump

Numerical Simulation of the Transient Flow in a Pump-Turbine During the Load Rejection Process With Special Emphasis on the Cavitation Effect

Research on Cavitation Characteristic of Inducer

Numerical investigation of cavitating flows in bulb tubular pump and its performance prediction

Cavitating Flow Analysis in a Closed Pump Sump

Transient flow analysis in reactor coolant pump systems during flow coastdown period

Experimental and numerical study on cavitation pulsating pressure of water-jet propulsion axial-flow pump

Experimental and numerical investigations of cavitation evolution in a high-speed centrifugal pump with inducer

Numerical Simulation and Analysis of Cavitation Flows in a Double Suction Centrifugal Pump

Analysis of Cavitation Behaviour in A Centrifugal Pump