Abstract:Mechanical strength, wear resistance, and corrosion resistance of surface coatings or surface-modified composites and their effects on the contact mechanics, tribology, and thermodynamics characteristics of elastohydrodynamic lubrication (EHL) in gears, bearings, and cams have been a subject of interest in the material and tribology science over the last few decades. On the basis of direct coupling method presented in this paper, the influence of coating materials on the characteristic parameters of EHL between gear meshing interfaces was investigated. Gear meshing interfaces were simplified to the contact between a cylinder and a plate. A local fluid–structure interaction (FSI) model enclosing the contact areas of the cylinder, plate, and the lubricant between them was established and solved with software ADINA. The hydrodynamic behavior of lubricant was calculated utilizing the Navier–Stokes (N-S) equations, and the viscosity and density variation, non-Newtonian fluid, and cavitation effect of lubricant were implemented through secondary development programs. The presented direct-coupled solution approach was verified by ball-on-disc experiments. EHL characteristic parameters of gear meshing interfaces under different coating’s Young’s moduli and thicknesses were studied, and results show that the TiN_E305 coating with larger Young’s modulus will contribute to the formation of secondary pressure peak, larger maximum film pressures both in the central contact area and secondary pressure peak region, and smaller contact half width. The opposite results were observed when the DLC_E70 coating with smaller Young’s modulus is used. All these effects increase with the increasing of coating thickness.Graphical abstractElastohydrodynamic lubrication (EHL) characteristic parameters of gear meshing interfaces under three different coating materials were discussed and showed.

Effect of Thermal Properties of A Coated Elastohydrodynamic Lubrication Line Contact under Various Slide-To-Roll Ratios

A Thermal Equilibrium Analysis of Line Contact Hydrodynamic Lubrication Considering the Influences of Reynolds Number, Load and Temperature

EHL Properties of Roller Contacts and Its Application Part Ⅱ: A Numerical Analysis of EHL for Engineering Logarithmic Roller

Effects of Thermal Properties of Contact Materials and Slide-Roll Ratio in Elastohydrodynamic Lubrication

Thermal mixed elastohydrodynamic lubrication modeling and analysis of the lubricated non-conformal contacts with non-Gaussian surface roughness and coating

Influence of Thermal Effects on Elastohydrodynamic (EHD) Lubrication Behavior at High Speeds

Numerical Analysis Of Point Contact Ehl On Coated Substrates

Effects of boundary slips on thermal elastohydrodynamic lubrication under pure rolling and opposite sliding contacts

Stress Analysis on Layered Materials in Point Elastohydrodynamic-Lubricated Contacts

Modeling of fully coupled thermo-elastic sliding contact of coated systems

Elastohydrodynamic Film Thickness in Elliptical Contacts with Spinning and Rolling

Elastic shakedown analysis of two-dimensional thermo-elastic rolling/sliding contact for a functionally graded coating/substrate structure with arbitrarily varying thermo-elastic properties

EHL Performance of the Lubricant with Shear Strength: Part I — Boundary Slippage and Film Failure

Analysis on Lubrication Contact Characteristics of Imperfect Transversely Isotropic Coating

Influence of coating material on elastohydrodynamic lubrication between gear meshing interfaces based on direct coupling solution

Influence of wall slip of lubricants on performance of elastohydrodynamic lubrication in line contact

About the Load-Carrying Capacity of Elastohydrodynamic Lubrication Film

Effect of thermo-elastic deformation on lubricated point contacts

An Analysis of Elastohydrodynamic Lubrication with Limiting Shear Stress: Part I—Theory and Solutions

A Full Numerical Solution for the Thermoelastohydrodynamic Problem in Elliptical Contacts

Oil Film Velocity Analysis in the Thermal Elastic Hydrodynamic Lubrication of Heavy Loading Point Contact