Abstract:Gamma imager capable of monitoring, detection and localization of radioactive sources is of critical importance for nuclear safety and homeland security with the increasing use of radioactive sources in applications of nuclear technology. A 4π view gamma imager based on gamma ray occlusion technique is under development in our lab. The key component of the gamma imager is a 3D position-sensitive detector, which enables 4π field of view of the imager. In this work, we propose a 3D positionsensitive detector design for the 4π view gamma imager based on dual-ended readout (DER) technique. The detector was composed of a GAGG block coupled to an SiPM array at both crystal ends. DOI calibration was conducted with a collimated fan beam 18F source and DOI resolution was evaluated. Energy calibration was performed for each 3D position region of the detector by incorporating 3D position information to correct for the energy response inconsistency at different 3D position regions inside the detector. Various radioisotopes including 99mTc, 131I, 137Cs and 22Na were tested. An exponential factor was applied to compensate for energy response non-linearity due to SiPM saturation effect at higher gamma energy. The measured average DOI resolution was 1.96 ± 0.21 mm for all the four DER detector modules, indicating excellent 3D positioning accuracy of the detector design. With the proposed energy calibration approach, characteristic photopeaks of each radioisotope can be clearly identified at the correct energy position on the measured energy spectra. The achieved energy resolution was 9.76% at 662 keV, demonstrating good energy performance of the detector design, which could benefit radioisotope identification capability of the gamma imager. To conclude, the proposed 3D position-sensitive detector design based on DER technique features good 3D positioning and energy performance and is feasible for the 4π view gamma imager.

Design and Optimization of A Dual-Hpge Gamma Spectrometer and Its Cosmic Veto System

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

Design of Cosmic Veto Shielding for HPGe-detector Spectrometer.

Sensitivity analysis of gamma spectroscopy system with dual high-purity germanium detectors

Developing a remote gamma-ray spectra collection system (RGSCS) by coupling a high purity Germanium (HPGe) detector with a cosmicguard background reduction device

Time evolution of rejected, coincidence spectra, registered on germanium gamma spectrometers with muon-sensitive veto shields

Optimal Design for a Μbq/kg Gamma Spectrometer Based on Monte Carlo Simulation

Prototyping a High Purity Germanium cryogenic veto system for a bolometric detection experiment

Design of a high-dynamic-range prototype readout system for VLAST calorimeter

Development of a New Γ-Ray Detector for PEM Applications

Design and Development of a 3D Position-Sensitive Detector for 4π View Gamma Imager Based on Dual-Ended Readout Technique

Preliminary Design of a Triggerless Readout System for CDEX-100 HPGe Detector Array

Spectroscopic performance evaluation and modeling of a low background HPGe detector using GEANT4

Simulation of background reduction and Compton depression in low-background HPGe spectrometer at a surface laboratory

Development of a high energy resolution and wide dose rate range portable gamma-ray spectrometer

Detection Efficiency Calculations Using Geant4 for a Broad-Energy Germanium Gamma Spectrometer

Cosmic-muon Intensity Measurement and Overburden Estimation in a Building at Surface Level and in an Underground Facility Using Two BC408 Scintillation Detectors Coincidence Counting System

Set up and test of an anticoincidence system for the detection of radioactive xenon by gamma spectrometry system

A plastic scintillator and HPGe β-γ coincidence detection system

Analysis of Gamma Rays and Cosmic Muons with a Single Detector

Characterization and performance of co-axial HPGe detectors