Abstract:The insulation condition is the key to determining whether gas insulated switchgears (GISs) can operate stably and reliably. Partial discharge (PD) detection is an important technique for condition monitoring and evaluation in GIS. Acoustic emission (AE) method is commonly used in on-site PD detection. However, in field applications, there are often problems such as low signal-to-noise ratio (SNR) of measured ultrasonic signals and difficulty in extracting PD pulses. To solve this problem, a denoising method for GIS ultrasonic signals based on the combination of ultrasonic and ultra-high frequency (UHF) signals is proposed in this paper. Based on the difference in correlation between noise and PD signals, the noise in measured signal can be suppressed through accumulating and averaging of multiple ultrasonic signals, and the SNR of PD signal can be significantly improved. An actual 500-kV GIS experiment platform is established, and PD measurements for different types of defects are conducted. Then, a comparative study is conducted on the denoising performance of the proposed method and traditional denoising methods such as wavelet method and singular value decomposition (SVD) method. The results indicate that compared to traditional methods, the method proposed in this paper has a higher reduction in noise level. Especially for extremely low-SNR signals (PD pulses buried in noise), traditional methods have poor performance, while the proposed method can still extract the PD pulse form the noise. Furthermore, based on the denoised ultrasonic signals, the defect localization analysis is conducted to demonstrates the correctness of the denoising results. Finally, the proposed method is applied to on-site PD detection, which further evaluates the effectiveness of the denoising method.

Severity Diagnosis and Assessment of the Partial Discharge Provoked by Protrusion in GIS

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

Investigation of Frequency Characteristics of Typical PD and the Propagation Properties in GIS

Examination and Research on the Partial Discharge Fault Diagnostics in Gas Insulated Switchgear

Diagnosis of Partial Discharge in GIS Based on UHF Sensing Technique

Propagation Attenuation Properties of Partial Discharge in Typical In-Field GIS Structures

Analysis Of The Intrinsic Characteristics Of The Partial Discharge Induced By Typical Defects In Gis

Propogation Characteristics of PD‐induced UHF Signal in 126 Kv GIS with Three‐phase Construction Based on Time–frequency Analysis

Partial Discharge Characteristics of a Void Defect inside an Actual 252-kV GIS Post Insulator

Research on the Typical Partial Discharge Using the UHF Detection Method for GIS

Partial Discharge Detection and Characteristics of Gas-insulated Substation Free Metal Particles Based on Acoustic Emission

Partial Discharge Characteristics of Submillimeter Metal Particles on the Insulator Surface in GIS with Long-time AC Stress

Partial Discharge Detection and Defect Location Method in GIS Cable Terminal

The Characteristics and Detection of the Partial Discharge Induced by the Micro Cracks in GIS Insulators

Discharge Characteristics and Detectability of Metal Particles on the Spacer Surface in Gas-Insulated Switchgears

Investigation on the Sensitivity of the UHF Method for Partial Discharge Detection in GIS

On Site Detection and Localization of Partial Discharge in Hydropower Plant GIL/GIS Based on Ultra-high Frequency Technique

Partial Discharge and Movement Characteristics of Micron-sized Metal Particles on Insulator Surface in Gas-Insulated Switchgear with Long-time AC Stress

Relationship Between Time-Frequency Representation of PD-induced UHF Signal and PD Current Pulse

A Denoising Method for Partial Discharge Ultrasonic Signals in GIS Based on Ultra-High Frequency Signal Synchronization