Abstract:The group-Ⅲ nitrides and their related ternary alloys have been becoming the most attractive material for light emitting diodes (LEDs) and laser diodes (LDs) in the UV and blue spectral range. However, the origins of the yellow luminescence (YL), which is commonly observed in almost undoped and n-type GaN, remain unclear. The nature and the role of initial nitridation of sapphire surface and the generation of threading dislocation (TD) are ambiguous too. It is a possible way to resolve the above problems by studying the microstructures and optical properties combining the growth conditions. In this work, two kinds of GaN films were grown by MOCVD under different initial nitridation time (180 seconds for Sample A, and 90s for Sample B). The growth temperature is about 950℃. The cross-sectional transmission electron microscope (TEM) is performed near the GaN/sapphire interface. Corresponding the growth processes, there are three zones in the GaN layer: buffer layer, zone and sound zone. There are haystack-like domains in the faulted zone, in which there are high density of extended defects. The thickness of the faulted zone is about 0.4μm. Just above this region, the defects density is reduced sharply, and the quality of the layer is improved, which is identified by electron diffraction (ED) patterns. In comparison, Sample A shows about an order lower density of extended defects than Sample B, their columnar diameter is larger and its ED pattern is sharper, too. The buffer layer of Sample B is more smooth than Sample A. The appropriate rougher morphology of the buffer layer may cause that the structural disorder between the high-temperature (HT) grown island and the buffer layer is accommodated by Frank and Shockley partial dislocations. However, the TD is likely to propagate into the HT GaN from the smooth surface of the buffer layer grown after extensively nitridation of substrate. According to the position and width of X-ray diffraction peaks of (0002) and (0004), the size of crystalline grain, D and the residual strain could be calculated. The values of(D,e in)of Sample A and B are (175nm,0.167%) and (90nm,0.141%), respectively. Small size of crystalline grain may be advantageous to relieve the lattice and thermal mismatch stress, but it lead to higher density of extended defects. The width of GaN (0002) reflections of Sample A is 4min lower than that of Sample B. This result may be due to the lower screw TD. The higher density of screw TD may widen the GaN (0002) peak in X-ray rocking curve. In room temperature PL spectra, the ratio of band-edge emission intensity to YL one of Sample A is 3 orders larger than that of Sample B. Furthermore the YL in Sample B is stronger and has fine structure, while that in Sample A is nearly invisible in the PL spectrum. The GaN epilayer with high quality exhibits almost no YL emission. It is well known that the YL corresponds to the deformed crystal structure. We assigned that the screw TD and mixed TD are attributed to the YL referring to our XRD results.

Characteristics of GaN-based light emitting diodes with different thicknesses of buffer layer grown by HVPE and MOCVD

Theoretical considerations on efficiency degradation due to thermal effect in a planar GaN-based LED with a GaN substrate

High‐Brightness Blue Light‐Emitting Diodes Enabled by a Directly Grown Graphene Buffer Layer

The Influences of Sputtered AlN Buffer Layer on AlInGaN Based Blue and Near‐ultraviolet Light Emitting Diodes

Growth and Characterization of Micro-LED Based on GaN Substrate

The Effect of Nanometer‐Scale V‐Pit Layer on the Carrier Recombination Mechanisms and Efficiency Droop of GaN‐Based Green Light‐Emitting Diodes

GaN-based Blue LEDs with Microstructure on P-Gan Surface Formed by Inductively Coupled Plasma Etching

Microstructural and Optical Properties of GaN Films on Nitrided Sapphire Substrates

Quasi-Homoepitaxial Gan-Based Blue Light Emitting Diode on Thick Gan Template

The improvement of GaN-based light-emitting diodes using nanopatterned sapphire substrate with small pattern spacing

Enhanced Output Power of Light-Emitting Diodes with Embedded Air-Gap Photonic Crystals by Nanosphere Lithography

Study of GaN-Based Light-Emitting Diode (LED) With a Hybrid Surface Structure

Improvement of the Emission Intensity of GaN-Based Micro-Light Emitting Diodes by a Suspended Structure

Optical Mode Pattern Study of GaN LEDs with and Without Top Nano-Gratings

Influence of Pillar- and Hole- Patterned Sapphire Substrates on Movpe Grown Gan Bulk and Led Structures

Planarization of p -GaN surfaces on MOCVD grown V-defect engineered GaN-based LEDs

Improved ESD Characteristic of GaN-based Blue Light-Emitting Diodes with a Low Temperature N-Type GaN Insertion Layer

Van der Waals epitaxy of GaN-based light-emitting diodes on wet-transferred multilayer graphene film

Limiting factors of GaN-on-GaN LED

Investigation of Modulation Bandwidth of InGaN Green Micro-LEDs by Varying Quantum Barrier Thickness

Improvement in Modulation Bandwidth of Micro-LED Arrays Based on Low-Temperature-Interlayer Approach