Abstract:The Chinese Accelerator Driven Sub-critical system (C-ADS) is an important strategic research that is based on a high energy proton beam for nuclear waste transmutation. To meet the requirements of stability and reliability of the lower energy part, two identical Injectors are operated in parallel. The Injector-I is designed and constructed by the Institute of High Energy Physics (IHEP) of the Chinese Academy of Sciences (CAS) in Beijing, China. The Injector-I linac with two accelerating cryomodules (named CM1 and CM2) successfully accelerated the proton beam to 10.67 MeV with the beam current of 10.11 mA in pulse mode and 10.0 MeV with a beam current of 1.6 mA in CW (continuous wave) mode. The cryomodules have been designed, fabricated, assembled and commissioned at IHEP since the beginning of 2012. The thermal performances of the cryomodules were analyzed with numerical simulations and the empirical calculations take into account all the main contributors (support posts, multilayer insulation, current leads, power couplers and cavities) to the static and dynamic heat loads at various temperature levels. Two designs of current leads are developed and analyzed, and the case 2 current leads are tested and used in the CM2. The estimated static heat loads by analysis have been compared with the available experimental measurements. The operation experiences including the cool down, operating parameters and heat load measurements are reported, and the results were shown that the cryomodules can keep in a stable operation at 2 K and 30 mbar +/- 10 Pa.

Physics design of the CIADS 25 MeV demo facility

Physics Design of the Superconducting Section of the CiADS Linac

Beam physics design of a superconducting linac

Commissioning of China ADS Demo Linac and Baseline Design of CiADS Project

Physics Design of the CiADS MEBT

The Status of CiADS Superconducting LINAC

Physics Design of A 10 Mev Injector Test Stand for an Accelerator-Driven Subcritical System

Physics Design of an Accelerator for an Accelerator-Driven Subcritical System

Beam Commissioning for a Superconducting Proton Linac

Physics design for the C-ADS main linac based on two different injector design schemes

Physics design for the C-ADS main linac basing on two different injector design schemes

Design and thermal performance of spoke cavity prototype cryomodule of the Chinese Accelerator Driven Sub-critical system Injector-I

DESIGN STUDIES OF THE C-ADS MAIN LINAC WITH ONLY SPOKE CAVITIES *

650 MHz Elliptical Superconducting RF Cavities for CiADS Project

Investigation and quantitative simulation of beam physics for 230 MeV SC cyclotron under construction at CIAE

Towards a high-intensity muon source at CiADS

Thermal Performance Analysis and Operation of the Spoke Cavity Cryomodules for C-ADS Injector-I

Development of the C-ADS SRF Accelerator at IHEP

Physics Design of CYCAIE-100

Beam Dynamics Design of the Superconducting Section of a 100ma Superconducting Linac

Beam dynamics of china-ads linac