Abstract:This paper describes the physical design of a 7 MeV proton linac injector for a synchrotron-based proton-therapy system, sponsored by the Chinese government under the support of the National Key Research and Development Program. The proton linac injector consists of an electron cyclotron resonance proton source, a low-energy beam transport section, a radio-frequency quadrupole (RFQ) accelerator, and an Alvarez-type drift tube linac (DTL). The peak current of the proton beam at the exit of the DTL accelerator is required to exceed 12 mA, with a normalized emittance of ⩽1.2π mm mrad (90% particles), a repetition rate of 0.5 Hz, and a beam pulse width of 40–100 μs. For the beam current whose momentum spread falls within ±0.3%, the intensity must exceed 8 mA. The design of the linac injector is optimized in the principle of adopting sophisticated domestic technologies and cost control. Only one tetrode-based RF power amplifier is required after minimizing the total peak-power consumption of the RFQ and DTL accelerator, which is 378 kW. The idea of the RF power lines feeding two cavities with one amplifier is presented. To facilitate the manufacture of permanent-magnet quadrupoles and reduce the cost, the focusing strength at the end of the RFQ accelerator is optimized. Consequently, the focusing strength of all permanent-magnet quadrupoles is the same, and the DTL accelerator can be directly connected to match the RFQ accelerator without a medium-energy beam transport section between them. After construction, the 7 MeV proton linac injector is hoped to be the first homemade linac injector for a synchrotron-based proton-therapy facility in China.

Physics design for the C-ADS main linac based on two different injector design schemes

Conceptual design of 5 MW-NBI injector for HL-2 M tokamak

Physics Design of an Accelerator for an Accelerator-Driven Subcritical System

Beam dynamics of china-ads linac

Beam physics design of a superconducting linac

Physics design of phase and energy adjustment for heavy ion beam of the same mass with two-charge state on BISOL

Error analysis and lattice improvement for the C-ADS Injector- I

Updating the CSNS injector linac to 250 MeV with superconducting double-spoke cavities

Design of a CW high charge state heavy ion RFQ for SSC-LINAC

Preliminary Design of CSNS-II Linac SRF LLRF

Design of a 10 MeV normal conducting CW proton linac based on equidistant multi-gap CH cavities

The design study for a 500 MeV proton synchrotron with CSNS linac as an injector

ERROR ANALYSIS AND CORRECTION SCHEME IN C-ADS INJECTOR-I*

Radiation Field Simulation of C-ADS Injector II

Multi-physics Analysis and Experiment of a CW Four-Rod RFQ

Physical design of a single-amplifier-driven proton linac injector for a synchrotron-based proton-therapy system in China

R&D of CEPC Injector Linac

Beam optics design of the superconducting region of the JAEA ADS

Beam dynamic design of a high intensity injector for proton linac

Transverse Profile Expansion and Homogenization at Target for the Injector Scheme-I Test Stand of China-ADS

Proposal and design of 81.25 MHz heavy ion drift tube linacs for BISOL