Abstract:The LiMnPO4 material has the advantages of abundant raw materials, safety and environmental protection, low price, high theoretical capacity, high stable working voltage platform and so on, showing great potential in lithium‐ion batteries. Dissimilar metal ion doping can essentially improve the electronic conductivity of LiMnPO4 and the material's charge and discharge performance, which is an ideal method to improve the electrochemical performance of LiMnPO4. In this paper, the optimal doping concentration of Mg‐doped solid solution material was calculated by first principles. At the same time, the corresponding content of LiMn1−xMgxPO4/C cathode material was synthesized by hydrothermal method for experimental verification, so as to prepare the cathode material with excellent electrochemical performance. The results show that the doping of Mg cations does not change the phase of the main phase, but significantly changes the crystal structure parameters. The regulation of the band width directly affects the electronic conductivity of the material, which is directly proportional to the electrochemical performance. EIS and CV test results show that a proper amount of magnesium doping can effectively reduce the impedance of the material, and can effectively alleviate the polarization phenomenon of LiMnPO4 electrode material, accelerate the diffusion rate of Li+, and it is easier to obtain high capacity battery. LiMn23/24Mg1/24PO4/C showed the best electrochemical performance, with an initial capacity of 153.8 mAh/g at 0.05C ratio and a capacity retention rate of 97.5% after 100 cycles at 0.05C ratio. The theoretical calculation is in good agreement with the experimental results, which indicates that the theoretical calculation based on first principles can effectively provide a more reliable theoretical basis for experimental design and subsequent improvement.

Magnesium Substitution to Improve the Electrochemical Performance of Layered Li2MnO3 Positive-Electrode Material

Modifying High-Voltage Olivine-Type LiMnPO4 Cathode Via Mg Substitution in High-Orientation Crystal

Elucidation of Synergistic Effect of Mg-co-doping on Electrochemical Performance of Mn-doped LiNiO2

Mg-doped Li1.133Ni0.2Co0.2Mn0.467O2 in Li Site As High-Performance Cathode Material for Li-ion Batteries

Effects of Mg Doping at Different Positions in Li-Rich Mn-Based Cathode Material on Electrochemical Performance

Excellent Rate Capability of Mg Doped Li[Li0.2Ni0.13Co0.13Mn0.54]O2 Cathode Material for Lithium-Ion Battery

Sodium substitution for partial lithium to significantly enhance the cycling stability of Li2MnO3 cathode material

Stabilizing the High-Voltage Cycle Performance of LiNi0.8Co0.1Mn0.1O2 Cathode Material by Mg Doping

Doping Mg2+ to Improve the Li+ Diffusion Rate and Electrochemical Performance of Spinel LiMn2O4

Relieving capacity decay and voltage fading of Li1.2Ni0.13Co0.13Mn0.54O2 by Mg2+ and PO43- dual doping

Magnesium Substitution in Ni‐Rich NMC Layered Cathodes for High‐Energy Lithium Ion Batteries

Surface Magnesium Substitution at Spinel Lithium Manganate 8a Tetrahedral Sites for Suppressed Manganese Dissolution and Enhanced Cycle Stability

Electrochemical Kinetics And Performance Of Layered Composite Cathode Material Li[Li0.2ni0.2mn0.6]O-2

Regulating Anionic Redox via Mg Substitution in Mn‐Rich Layered Oxide Cathodes Enabling High Electrochemical Stability for Sodium‐Ion Batteries

Enhanced Cycling Performance of Spinel LiNi0.5Mn1.5O4 Cathodes through Mg-Mn Hetero-Valent Doping via Microwave Sol-Gel Method

The prepared and electrochemical property of Mg-doped LiMn0.6Fe0.4PO4/C as cathode materials for lithium-ion batteries

Stabilization of Li 2 MnO 3 phase by Mg doping suppressing irreversible oxygen loss and Mn ions migration

Insight into structural and electrochemical properties of Mg‐doped LiMnPO4/C cathode materials with first‐principles calculation and experimental verification

Preparation and performance of Mg-doped spinel-structured LiMn2O4 cathode materials

Promoting reversible reaction of oxygen anions in cobalt-free lithium-rich layered oxides to improve their electrochemical performance

Improving the stability of P2-type NaMn2/3Ni1/3O2 via phasic intergrowth induced by Li-ion substitution