Abstract:Ni-rich layered LiNi x Co y Mn 1− x − y O 2 ( x ≥ 0.6) cathodes suffer from the extreme structural instability of their surface and interior owing to high Ni content. Although the structural design of full-concentration-gradient (FCG) better solved their surface instability, the deterioration of internal structure caused by the higher Ni content in the interior of particles became more prominent, and seriously limiting the cycle performance of FCG Ni-rich layered cathode materials. In this study, a strategy for the internal structure regulation by magnesium doping was proposed to overcome the internal structure instability of FCG Ni-rich layered LiNi 0.80 Co 0.05 Mn 0.15 O 2 (FNCM) cathode materials. The experimental results and DFT calculations revealed that Mg 2+ doping not only suppresses the layer structure collapse and H2–H3 phase transition but also improves the electronic conductivity by enhancing the free electron number near the Fermi level. The enhancement of the internal structure stability and dynamic migration process of ions and electrons contributed to improving cycle stability. As a result, the 0.02 mol% Mg 2+ doped sample delivers an outstanding initial discharge specific capacity of 182.6 mAh g −1 at 1C with a satisfactory capacity retention of 90.7% after 200 cycles, which is higher than that of the original sample (capacity retention of only 81.3%). Most importantly, it still exhibits excellent capacity retention of 82.5% and 83.3% at a high cutoff voltage (4.5 V) and a high temperature (50 °C) after 200 cycles, respectively. These results indicated that magnesium doping is an attractive strategy to further improve the cycle stability of FCG Ni-rich cathode materials.

Mg Doping Improving the Cycle Stability of LiNi 0.5 Mn 0.5 O 2 at High Voltage

Elucidation of Synergistic Effect of Mg-co-doping on Electrochemical Performance of Mn-doped LiNiO2

Stabilizing the High-Voltage Cycle Performance of LiNi0.8Co0.1Mn0.1O2 Cathode Material by Mg Doping

Mitigation of Cation Mixing of LiNiO2-based Cathode Materials by Li-doping for High-Performing Lithium-Ion Battery

Mg-doping and electrochemical properties of Li (Ni1/3Co1/3Mn1/3) O2cathode material

Stabilization of Li 2 MnO 3 phase by Mg doping suppressing irreversible oxygen loss and Mn ions migration

Enhanced Cycling Performance of Spinel LiNi0.5Mn1.5O4 Cathodes through Mg-Mn Hetero-Valent Doping via Microwave Sol-Gel Method

Regulating the internal structure by magnesium doping to enhance cycle stability of full-concentration-gradient Ni-rich layered cathodes

Improving the electrochemical performances of Li-rich Li1.2Ni0.13Co0.13Mn0.54O2 through cooperative doping of Na+ and Mg2+

Doping Mg2+ to Improve the Li+ Diffusion Rate and Electrochemical Performance of Spinel LiMn2O4

Effect of Mn Doping on the Structure and Electrochemical Performance of LiNi0.7Co0.3O2

Mg-doped Li1.2Mn0.54Ni0.13Co0.13O2 Nano Flakes with Improved Electrochemical Performance for Lithium-Ion Battery Application

Excellent Rate Capability of Mg Doped Li[Li0.2Ni0.13Co0.13Mn0.54]O2 Cathode Material for Lithium-Ion Battery

An Mg–Al dual doping strategy to enhance the structural stability and long cycle life of LiNi0.8Co0.1Mn0.1O2 cathode material

Effects of Mg Doping at Different Positions in Li-Rich Mn-Based Cathode Material on Electrochemical Performance

Electrochemical performances of LiNi0.83Co0.12Mn0.05O2 by dual doping of Mg and Ti

Preparation and performance of Mg-doped spinel-structured LiMn2O4 cathode materials

Structural and Electrochemical Properties of Mg-doped Nickel Based Cathode Materials LiNi0.6Co0.2Mn0.2−xMgxO2for Lithium Ion Batteries

High-Voltage Na0.76Ni0.25- x/2Mgx/2Mn0.75O2- xFx Cathode Improved by One-Step In Situ MgF2 Doping with Superior Low-Temperature Performance and Extra-Stable Air Stability

Relieving capacity decay and voltage fading of Li1.2Ni0.13Co0.13Mn0.54O2 by Mg2+ and PO43- dual doping

Effect of doping amount on capacity retention and electrolyte decomposition of LiNi0.5Mn1.5O4-based cathode at high temperature