Abstract:In this study, a novel sol-gel method is used to synthesize amorphous silica-alumina materials with a narrow mesoporous distribution and various Si/Al molar ratios without using any templates and pore-regulating agents. During the preparation procedure, only inexpensive inorganic salts were used as raw materials, instead of expensive and harmful alkoxides. The precursor sol was dried at room temperature in a vacuum box kept at 60 mmHg until it began to form the gel. The results of a nitrogen sorption experiment indicate that the synthesized materials with different Si/Al molar ratios have similar mesoporous distributions (within 2-12 nm). Moreover, it was found that the material's pore size distribution remains at a similar value during the heat treatment from room temperature to 550 degreesC. On the basis of the nitrogen sorption, TEM, and AFM characterization results, a formation mechanism of mesopores which accounts for the experimental data is also suggested. This suggested mechanism involves rearrangement of the primary particles during the drying process to form the precursors of the similarly sized mesopores. The synthesized materials were characterized by XRD, thermal analysis (TG/DTA), Al-27 and Si-29 MAS NMR spectroscopy, SEM, TEM, and AFM. The results of Al-27 and 29Si MAS NMR indicate that the distribution of silicon and aluminum in the synthesized materials is more uniform and homogeneous than that in the mixed oxides prepared via the traditional sol-gel method even at high alumina contents. The type and density of the acid sites were studied using pyridine adsorption-desorption FTIR spectroscopy. It was shown that the acidity of the synthesized materials is higher than that of the silica-alumina materials prepared by conventional methods.

A New Sol-Gel Route to Prepare Dense Al2O3 Thin Films

Preparation of Al2O3dense films using sol derived from Al(NO3)3·9H2O

Preparation Of Al2o3 Dense Films Using Sol Derived From Al(No3)(3)Center Dot 9h(2)O

The Microstructure, Morphology, and Mechanical Properties of Sol-Gel-derived Amorphous Aluminum Oxide Films

Optical properties of amorphous Al2O3 thin films prepared by a sol–gel process

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

New Method for Making Porous SiO2 Thin Films

Preparation of Alumina Ultrafine Powders Through Acrylamide, Starch and Glutaric Dialdehyde Mediated Sol–gel Method

Preparation And Characterisation Of Al2o3 Film On Hollow Glass Microspheres By The Sol-Gel Process

New sol-gel route using inorganic salt for synthesizing Al2O3 nanopowders

Facile synthesis of nano-crystalline alpha-alumina at low temperature via an absolute ethanol sol-gel strategy

Fabrication of LaAlO3 Film by Sol-Gel Process with Corresponding Inorganic

A Novel Method To Synthesize Amorphous Silica−Alumina Materials with Mesoporous Distribution without Using Templates and Pore-Regulating Agents

Preparation and Characterization of LiTaO 3 Films Derived by an Improved Sol-Gel Process

Facile Preparation of Hydrophobic Aluminum Oxide Film via Sol-Gel Method

Preparation of high quality amorphous Al2O3 thin film on silicon and its applications

The construction of pyramid structure of micro aluminum oxide

Chemical and Structural Characterization of Amorphous and Crystalline Alumina Obtained by Alternative Sol–Gel Preparation Routes

Al2O3 Thin Layer Formed Inside Porous Membrane Using Spray Synthesis Method and Its Application

Enhanced Sol–Gel Route to Obtain a Highly Transparent and Conductive Aluminum-Doped Zinc Oxide Thin Film

Preparation of SiOx Film by Sol-gel Process and Its Adhesion to Al Substrate