Oxyfuel Combustion Conference Mechanisms for Calcination and Sulfation of Limestone during Oxy-Fuel Combustion
Juan Chen,H. Yao,Minghou Xu,Xiaojiang Wu,Lian Zhang
2011-01-01
Abstract:This paper aims to clarify the mechanisms governing the calcination and sulfation of limestone during oxy-fuel combustion. Apart from pure limestone, the mixtures of limestone with a low-rank brown coal at three different mass ratios were combusted in an lab-scale drop-tube furnace (DTF) to systematically examine the influences of a number of single parameters, including gas composition (i.e. 27% O2/ 73% CO2 versus air), flame temperature, ash to limestone mass ratio and the concentration of SO2 in the furnace. The furnace temperature and nominal gas residence time were fixed at 1000C and 4 sec, respectively. The ash sample was collected through dry ice quenching, and analyzed by TGA to quantify the unreacted CaCO3 fraction, X-ray fluorescence spectroscopy (XRF) for elemental quantification and X-ray Diffraction Spectrometer (XRD) for the speciation of crystallized structures. The results indicate that, for the pure limestone, its calcination in 27% O2/73% CO2 was significantly inhibited by the large pressure of CO2, as expected. However, once coal is added with limestone together into the furnace, the fl ame formed by coal volatile oxidation outweighed the negative in fluence of CO2 partial pressure, accordingly, the limestone decomposition in 27% O2/73% CO2 was increased to the similar level with that observed in air, due to the same fl ame temperature confirmed in these two gases. The coal-bound fly ash also posed promoting effect on the decomposition of limestone, potentially through the initial formation of calcium alumino-silicate on the limestone surface, which was subsequently shed away by bulk gas. A fresh surface of limestone was thus exposed into bulk gas to continue decomposition or undergo sulfation. It was also confirmed that, the direct sulfation of limestone to CaSO4 played an important role on the sulfur capture in O2/CO2. Its reaction rate is slightly slower than the sulfation reaction of calcium oxide at the higher SO2 content in flue gas..