Abstract:Supported sorbent for flue gas desulfurization was prepared by a process of hydrating and drying a mixture of carrier particles and lumps of CaO in previous studies. Supported sorbent achieves high desulfurization efficiency in a Circulating Fluidized Bed (CFB) reactor at moderate temperature. However, the preparation process is complicated, which makes industrial application difficult. In this study, supported sorbent is prepared in situ in a CFB reactor by a coating process, in combination with SO2 removal. The experiments are conducted in a pilot-scale CFB experimental facility at 700-750 degrees C. The influence of operation parameters on supported sorbent formation and desulfurization efficiency is tested, including bed inventory, sprayer location, and spray method. The results show that the present process achieves 85.3% desulfurization efficiency with a Ca/S molar ratio of 2.01 when the bed inventory is 25 kg. This result is approximately 10 times higher than that of a zero bed inventory. The scanning electron microscope and energy dispersive spectrometer results show that the supported sorbent forms when fine Ca(OH)(2) particles in the lime slurry adhere to the bed material surface. The residence time of the supported sorbent in the CFB reactor is significantly longer than that of the fine Ca(OH)(2) particles. The adhesion efficiency is influenced by the spray location and spray method. The desulfurization performance of the supported sorbent prepared by the original hydration and drying method is also tested. The desulfurization efficiency is 25-35% higher than the present process because there is better adhesion in the original method than the in situ method. But the process complexity is significantly reduced when using the present process. The present process is a substantial attempt toward the application of supported sorbent.

Experimental Study of the Mechanisms of Steam Reactivation of Unreacted Calcium-Based Sorbent for Flue Gas Desulphurisation

Experimental study of steam reactivation of calcium-based sorbent for dry FGD process

Experimental study of steam activation of calcium-based sorbents for dry-scrubbing dechlorinate

Experimental Study on Effect of Sorbent Pore Structure by Steam Activation in the Medium Temperature Desuffurization Process

MECHANISM OF IMPROVING THE MEDIUM TEMPERATURE FGD PROCESS BY REACTIVATING SORBENTS BY STEAM

Partially Sulfated Lime-Fly Ash Sorbents Activated by Water or Steam for SO2 Removal at a Medium Temperature

Experiment on Humidification and Desulphurization of Calcium-Based Spent Sorbent at Low Temperature with Thermogravimetric Analyzer

Experimental study of steam activation effect on CaO sorbent pore structure and capacity for SO2 removal

Study on desulfurization reaction characteristic of calcium-based sorbents

Research on Vapor Mercury Adsorption by Ca-Based Sorbents

Desulfurization Characteristic of Calcium-Based Sorbent During Activation Process.

EXPERIMENTAL STUDY ON THE CATALYSIS EFFECT OF STEAM IN THE DRY FLUE GAS DESULFURIZATION REACTION BY CaO PARTICLES

Steam Hydration Reactivation of Cao-Based Sorbent in Cyclic Carbonation/Calcination for Co2 Capture

Experimental study of hot gas desulphurization with limestone sorbent

Experimental Study on the Removal of SO3 from Coal-Fired Flue Gas by Alkaline Sorbent

EXPERIMENTAL INVESTITGATION ON IMPROVING PERFORMANCE OF CALCINING CALCIUM DESULFURIZATOR

EXPERIMENTAL STUDIES ON DESULFURIZATION OF CALCIUM BASED SORBENT IN O2/CO2 COAL COMBUSTION

Kinetic model for desulfurization at medium temperature using hydrated absorbent

Experimental Study On Medium Temperature Dry Flue Gas Desulphurization By Using Active Sorbent In Circulating Fludized Bed

Experimental Study on in Situ Preparation of Supported Sorbent for Moderate Temperature CFB-FGD

Study on SO2 removal of calcium sorbent mixed with pulverized coal ash