Abstract:Increasing deployment of optical fiber networks and the need for reliable high bandwidth make the task of inspecting optical fiber connector end faces a crucial process that must not be neglected. Traditional end face inspections are usually performed by manual visual methods, which are low in efficiency and poor in precision for long-term industrial applications. More seriously, the inspection results cannot be quantified for subsequent analysis. Aiming at the characteristics of typical defects in the inspection process for optical fiber end faces, we propose a novel method, “difference of min-max ranking filtering” (DO2MR), for detection of region-based defects, e.g., dirt, oil, contamination, pits, and chips, and a special model, a “linear enhancement inspector” (LEI), for the detection of scratches. The DO2MR is a morphology method that intends to determine whether a pixel belongs to a defective region by comparing the difference of gray values of pixels in the neighborhood around the pixel. The LEI is also a morphology method that is designed to search for scratches at different orientations with a special linear detector. These two approaches can be easily integrated into optical inspection equipment for automatic quality verification. As far as we know, this is the first time that complete defect detection methods for optical fiber end faces are available in the literature. Experimental results demonstrate that the proposed DO2MR and LEI models yield good comprehensive performance with high precision and accepted recall rates, and the image-level detection accuracies reach 96.0 and 89.3%, respectively.

A Testing Technology for Optical Fiber Connector End Surface

Three measurement algorithms of PMF geometric parameters

Digital testing of transmitted wavefront distortion for micro-optics

Actively stabilized optical fiber interferometry technique for online/in-process surface measurement.

Near Common-Path Optical Fiber Interferometer for Potentially Fast On-Line Microscale-Nanoscale Surface Measurement

Measurement of Aspheric Surface

A Simple Approach to Fiber-Based Tunable Microcavity with High Coupling Efficiency

Automated Inspection of Defects in Optical Fiber Connector End Face Using Novel Morphology Approaches

A General Characterizing Method for Optical Filter Based on Low Coherence Measurement

Confocal Image 3D Surface Measurement with Optical Fiber Plate

Research on vision-based waveguide alignment of optical fiber

Test and measurement of self-built optical fiber links based on OTDR and its teaching practice

Interferential Image Process in the Measuring of Surface Topography for Fiber Ferrule End-Face

The Application of OTDP To the Test of Optical Fiber

Study on Multi‐time Reflection Induced by In‐line Fiber Connector in Engineering Applied Distributed Single‐fiber Interferometer Sensing System

A New Optical Fiber Sensor And Its Calibration Method

Surface Testing Methods of Aspheric Optical Elements

Optical Fiber Internal-Mirror-based Fiber In-Line Mach-Zehnder Interferometer

Application of Distributed Optical Fiber Sensing to Testing Inner Force of Prefabricated Piles

A Long-Haul and High-Accuracy Fiber Length Measurement Technology Based on Mach-Zehnder and Sagnac Hybrid Interferometer

Optical testing method and its experiment on freeform surface with computer-generated hologram