Abstract:It is not uncommon for pump-turbine units in pumped storage power plants to experience load rejections due to the sudden disconnection of the generator from the power grid. Load rejection can suddenly increase the rotating speed of the pump-turbine and cause strong pressure fluctuations in the flow passage of the pump-turbine unit. During load rejection, the strong pressure fluctuations caused by the water hammer effect can cause strong structural vibrations, high stresses and even damage to the turbine runner, head cover, stay ring, bottom ring, head cover bolts and bottom ring bolts. In order to study, in detail, the flow-induced stress characteristics of the prototype pump-turbine unit, and the pressure variations during load rejection in a high-head pumped storage power plant were measured first. Then the measured data were used to set up computational fluid dynamics (CFD) simulations in the entire flow passage of the prototype pump-turbine and to calibrate the simulation results. The calculated pressure distributions in the flow passage during load rejection were exported and mapped on the finite element model of the stationary structures of the pump-turbine unit so that the flow-induced stresses on the head cover, stay ring, bottom ring, head cover bolts and bottom ring bolts can be calculated. The results of the analysis show that the maximum stresses in the head cover bolts and bottom ring bolts are located on the rounded corner of the bolt near the stay ring and that the stresses in the bolts vary with time during load rejection. The maximum stresses of the head cover bolts are higher than the maximum stresses of the bottom ring bolts, and the maximum stresses of the bolts are above two-thirds of the yield strength of the bolt material. It is recommended to use larger nominal diameter bolts to avoid damage to the connecting bolts of the pump-turbine unit.

Analysis of Bolt Sealing Stress of 600MW Turbine High Pressure Cylinder in Different Working Situation

FEM-based Multi-field Coupling Stress Analyses of the Cylinder-bolts System in a Gas Turbine Power Plant

TO CALCULATE THE STRENGTH OF TURBINE＇S DIAPHRAGM BY USING FINITE ELEMENT METHOD

Pressure pulsation analysis of runner and draft tube of pump turbine under different working conditions

Research on Optimization of Intermediate Pressure Cylinder Start Process for 600MW Unit

Analysis of the Sealing Performance and Creep Behavior of the Inner Casing of A 1000 Mw Supercritical Steam Turbine under Bolt Relaxation

TEMPERATURE FIELD AND THERMAL STRESS FINITE ELEMENT ANALYSIS OF A 50MW STEAM TURBINE'S CYLINDER IN A POWER PLANT

Mechanical Behavior Study of Steam Turbine Casing Bolts under In-Service Conditions

Stress Characteristic Analysis of Pump-Turbine Head Cover Bolts During Load Rejection Based on Measurement and Simulation

Analysis of material fault of O-ring seal in aircraft cylinder

Analysis on High Temperature Strength and Sealing Behavior of U-type Seal in Steam Turbine Valves

Failure Analysis on the Bolt Connecting the Head-Cover and Stay Ring in Pumped Storage Unit: Part Ⅰ-Experimental Study

Study on dynamic stress variation of head cover bolt during transient operation of pump turbine

Thermal Stress Analysis of Finite Element Method of High Pressure Blade Ring of Subcritical 600MW Turbine

Failure analysis on the bolt connecting the head-cover and stay ring in pumped storage unit: Part I-Experimental study

Analysis of Reasons for Inner Opening in Inside Cylinder of 600 MW Supercritical Steam Turbine

Analysis Of High Temperature Creep On The Nut Connection Components Of A 600mw Supercritical Steam Turbine

Analysis of the Temperature and Stress Field in a Steam Turbine Bypass Valve Body

Stress Analysis of Screw Connection of Key Structural Components in Pump Turbine

Structural characteristics analysis of extra–high–head pump–turbine-unit under extreme-pressure working-conditions

Analysis of the Structural Optimization of Bolts Destined for the Coupling of a 600 MW Unit Low-voltage Generator