Abstract:In order to study the whole process of the high temperature liquid slag fly ash produced after the combustion of high alkali coal as power coal in the boiler furnace, which moves in the furnace and impinges on the water wall, the heat exchange occurs and then the cooling phase transformation deposits and slags, and the possible factors of slagging particles are studied by changing the environmental variables. In this paper, based on Smoothed Particle Hydrodynamics (SPH), the dynamic behavior of boiler molten ash impacting vertical wall is studied, and the flow spreading and solidification model of molten slag impacting vertical wall is established. Thus, the process of phase change deposition of slag particles against wall is simulated. By observing the phase distribution of slag and the change in spreading process, the complete process of the slag particles hitting the wall, spreading, shrinking and solidifying is analyzed. Based on the cohesive and repulsive surface force method, a temperature-dependent surface tension model is established to simulate the effect of surface tension on flow characteristics when molten ash impinges on low-temperature vertical walls. The influences of slag impact velocity, initial temperature and water wall temperature on deformation and solidification heat transfer are discussed. The results show that the initial velocity and initial temperature of slag particles affect the phase change deposition velocity and the final spreading factor of slag, while the temperature of the water wall has little effect on the deposition deformation and solidification process of slag.

Modeling Research on Impaction Between High-Cao Ash and Droplets for Humidification Desulfurization

Modeling Study on the Impaction and Humidification Process in Desulfurization Activation Reactor

A general mechanistic model of fly ash formation during pulverized coal combustion

Investigation On The Ash Deposition Of A Radiant Syngas Cooler Using Critical Velocity Model

AN EXPERIMENTAL INVESTIGATION ON HUMIDIFIED ACTIVATION FLUE GAS DESULFURIZATION WITH HIGH CaO CONTENT FLY ASH

Modeling on circulating fluidized bed flue gas desulfurization

Dynamic CFD modeling and evaluation of ash deposition behaviors during Zhundong coal combustion

Study on Humidification and Desulfurization of High-CaO Coal Ash with A Thermobalance

Numerical Simulation of Multiphase Flow and Collision Humidification in the Multifluid Alkaline Spray Generator for a Novel Semidry Flue Gas Desulfurization System

Tga Study on Humidified Activation and Desulfurization Performance of High-Cao Coal Ash at Low Temperature

A MODEL FOR PREDICTING HEAT TRANSFER PROCESS WITH COAL ASH DEPOSITION IN UTILITY BOILERS

Modeling Of The Aqueous Ca(Oh)(2) Reaction Under Semi-Dry Fgd Condition

Experimental and model investigation on the mass balance of a dry circulating fluidized bed for flue gas desulfurization system

STUDY ON DESULFURIZATION CHARACTERISTIC IN CaO ACTIVATION REACTOR OF LIMESTONE INJECTION FGD SYSTEM Ⅰ--MATHEMATICS MODEL

Experimental study on influence of multi-stage humidification on semi-dry flue gas desulfurization

D306 EXPERIMENTS AND MATHEMATICAL MODEL ON FLUE GAS DESULFURIZATION OF CIRCULATING FLUIDIZED BED

CFD Modeling of Ash Deposition Distribution in an Industrial Radiant Syngas Cooler to Enhance the Operation Performance

Numerical simulation of solidification of boiler molten ash impinging on vertical wall based on Smoothed Particle Hydrodynamics method

Modeling of Sulfur Retention in Circulating Fluidized Bed Coal Combustors

Numerical Simulation of Ash Deposition Behavior in Radiant Syngas Cooler Coupled with Impact Surface Temperature

Mass transfer process intensification for SO2 absorption in a commercial-scale wet flue gas desulfurization scrubber