Synthesis of amidoxime adsorbent prepared by radiation grafting on upcycled low-density polyethylene sheet for removal of heavy metals from wastewater
Vareeporn Ratnitsai,Wijittra Wongjaikham,Doonyapong Wongsawaeng,Kanokporn Kohmun,Somtop Santibenchakul,Koranat Narkpiban
DOI: https://doi.org/10.1038/s41598-024-69320-8
2024-08-10
Abstract:The issue of discharging waste, especially heavy metals from industrial activities into the environment, not only adversely impacts environmental quality but also has impacts on communities and human health. Removal and reduction of heavy metal contamination in rivers and wastewater are, therefore, critical initiatives that require significant attention. This work studied the removal of heavy metals, including Zn(II), Cu(II), As(III), and Pb(II) by utilizing an upcycled amidoxime low-density polyethylene sheet (AO-sheet). The synthesized AO-sheet was analyzed for various physical properties, including scanning electron microscope, energy-dispersive x-ray spectroscopy, Fourier transform infrared spectroscopy, and thermogravimetric analysis. For the batch adsorption experiment, parameters affecting adsorption capacity were studied: initial concentration, submerging time, and pH. Adsorption isotherms were also studied. The results of the heavy metal adsorption study showed that the initial concentration was the most significant parameter; the higher the initial concentration, the greater the adsorption capacity. The adsorption capacity of Zn(II) and Pb(II) increased with submersion time, which achieved 21.07 and 0.855 mg/g-adsorbent, respectively, after four weeks of submersion under the highest initial concentration studied. The adsorption capacity of Cu(II) was 7.98 mg/g-adsorbent after two weeks of optimal adsorption duration under the highest initial concentration studied. The adsorption capacity of As(II) was 1.07 mg/g-adsorbent after one week of optimal submersion time under the highest initial concentration studied. Moreover, the appropriate pH range for effective adsorption of Zn(II), Cu(II), and Pb(II) was identified as 8-9, while for As(III), it was 6-8, with an adsorption duration of 0.43 weeks (3 days). From the Langmuir isotherm, it was found that the adsorption of this work was characterized by monolayer adsorption. The results demonstrate that the AO-sheet can be effectively used to remove heavy metals from wastewater. Its potential for reusability was up to 8 cycles, with the Zn(II) adsorption capacity being reduced to about 20.37%.