Abstract:The issue of discharging waste, especially heavy metals from industrial activities into the environment, not only adversely impacts environmental quality but also has impacts on communities and human health. Removal and reduction of heavy metal contamination in rivers and wastewater are, therefore, critical initiatives that require significant attention. This work studied the removal of heavy metals, including Zn(II), Cu(II), As(III), and Pb(II) by utilizing an upcycled amidoxime low-density polyethylene sheet (AO-sheet). The synthesized AO-sheet was analyzed for various physical properties, including scanning electron microscope, energy-dispersive x-ray spectroscopy, Fourier transform infrared spectroscopy, and thermogravimetric analysis. For the batch adsorption experiment, parameters affecting adsorption capacity were studied: initial concentration, submerging time, and pH. Adsorption isotherms were also studied. The results of the heavy metal adsorption study showed that the initial concentration was the most significant parameter; the higher the initial concentration, the greater the adsorption capacity. The adsorption capacity of Zn(II) and Pb(II) increased with submersion time, which achieved 21.07 and 0.855 mg/g-adsorbent, respectively, after four weeks of submersion under the highest initial concentration studied. The adsorption capacity of Cu(II) was 7.98 mg/g-adsorbent after two weeks of optimal adsorption duration under the highest initial concentration studied. The adsorption capacity of As(II) was 1.07 mg/g-adsorbent after one week of optimal submersion time under the highest initial concentration studied. Moreover, the appropriate pH range for effective adsorption of Zn(II), Cu(II), and Pb(II) was identified as 8-9, while for As(III), it was 6-8, with an adsorption duration of 0.43 weeks (3 days). From the Langmuir isotherm, it was found that the adsorption of this work was characterized by monolayer adsorption. The results demonstrate that the AO-sheet can be effectively used to remove heavy metals from wastewater. Its potential for reusability was up to 8 cycles, with the Zn(II) adsorption capacity being reduced to about 20.37%.

Preparation and Characterization of a Novel Amidoxime-Modified Polyacrylonitrile/Fly Ash Composite Adsorbent and Its Application to Metal Wastewater Treatment

Adsorption of Metal Ions in Wastewater on Fly Ash

Amidoxime modification of polyacrylonitrile/Pterocladia capillacea-derived activated carbon composite for adsorption of toxic chromium from aquatic environment

Polyvinyl alcohol modified chitosan composite as a novel and efficient adsorbent for multi-metal removal

Design of amphoteric MOFs-cellulose based composite for wastewater remediation: Adsorption and catalysis

Fabrication and Characterization of Novel ZnAl-Layered Double Hydroxide for the Superadsorption of Organic Contaminants from Wastewater

An investigation on the amorphous zirconium phosphate compositing with cotton for the removal of heavy metal ions

Preparation of Humic Acid-Bentonite Polymer Composite: A Heavy Metal Ion Adsorbent

Synthesis and Characterization of Zinc Oxide Nanoparticle Anchored Carbon as Hybrid Adsorbent Materials for Effective Heavy Metals Uptake from Wastewater

Simultaneous removal of Zn2+ and p-nitrophenol from wastewater using nanocomposites of montmorillonite with alkyl-ammonium and complexant

Synthesis of amidoxime adsorbent prepared by radiation grafting on upcycled low-density polyethylene sheet for removal of heavy metals from wastewater

Synthesis and application of magnetite polyacrylamide amino-amidoxime nano-composites as adsorbents for water pollutants

Preparation of ZIF‐8‐Based Functionalized Magnetic Nanocomposites and Their Application in Aqueous Environment

Synthesis of amidoximated polyacrylonitrile fibers and its use as adsorbent for Cr (VI) ions removal from aqueous solutions

Compressible nanowood/polymer composite adsorbents for wastewater purification applications

Removal of Cu(II) from aqueous solutions by novel EDA-functionalized clay nanocomposite fabricated as nanoadsorbents

The study of removal Pb(II) and Ni(II) from aqueous solution by new adsorbent materials of nano-Mg(OH)2/fly ash

Enhanced selective removal of lead ions using a functionalized PAMAM@UiO-66-NH2 nanocomposite: Experiment and mechanism

Advancing wastewater treatment and metal recovery: Aminated ZIF-8 composite cellulose aerogel as an innovative biomass adsorbent for enhanced molybdenum ion adsorption

Modified fly ash as an effect adsorbent for simultaneous removal of heavy metal cations and anions in wastewater

Synthesis of ZIF-8/Fly Ash Composite for Adsorption of Cu2+, Zn2+ and Ni2+ from Aqueous Solutions