Abstract:Enhancing the aerodynamic performance of compressors requires a thorough investigation and management of highloss flow in the corner. This study introduces a new combined control method that integrates the Blended Blade and EndWall (BBEW) profile with Vortex Generator (VG) to optimize corner separation on the endwall. To evaluate the effectiveness of the combined control method and explore the fundamental physical principles governing corner separation, numerical simulations of the prototype and combined control design were conducted in a linear cascade. Based on the findings, the BBEW profile increases the angle between the blade and the endwall, allowing low-energy fluid to enter the mainstream more easily. This weakens the boundary layer interaction in the corner region, delaying the start of separation. Additionally, applying VG to the endwall creates downstream vortices that improve mixing between mainstream and low-energy fluid and push the low-energy fluid downward. As a result, viscosity and vorticity near the hub are reduced, effectively minimizing negative effects. VG significantly reduces losses in the 20% to 32% span range while BBEW counteracts the losses introduced by VG in the 5% to 25% range. The combined control method results in the most significant reduction in losses, surpassing the individual effects of VG and BBEW. It effectively eliminates the Corner Vortex (CV) and reduces the Passage Vortex (PV), resulting in a more stable flow. Overall, the combined control approach effectively mitigates corner separation by improving secondary flow and boundary layer interaction, thereby greatly enhancing compressor performance.

Effects of End-Wall Vortex Generator Jet on Flow Separation Control in Compressor Cascade under Different Angles of Attack

PIV investigation on corner separation control in a compressor cascade based on a vortex generator

Combined Control Method and Mechanism Analysis for Corner Separation in a Compressor Cascade

Separation Control Using Synthetic Vortex Generator Jets in Axial Compressor Cascade

Vortex structure control based bleed in axial compressor cascade with tip clearance using large eddy simulation

Experimental study on multi-angle pulsed jet actuators for controlling corner separation flow in a compressor cascade

Numerical Study of the Effect of Secondary Vortex on Three-Dimensional Corner Separation in a Compressor Cascade

Vortex Generator Evaluation Models and Flow Mechanisms for Compressor Cascade

Effect of a blade end slot on supersonic compressor cascade hub-corner separation

Mach 3.5 Compression Corner Control Using Microvortex Generators

Corner Separation Control Using Sweeping Jet Actuator in a Compressor Cascade

Numerical Simulation of Effect of Blade End Slot on Performance of Compressor Cascade

Impact of Slots on the Aerodynamic Performance of the Variable Inlet Guide Vane Cascade of a Centrifugal Compressor

Influence of Sub Boundary Layer Vortex Generator Height and Attack Angle on Cross-Flows in the Hub Region of Compressors

Control of Unsteady Separated Flows Inside Axial Compressors by Synthetic Jets

An Investigation on Separation Configurations in Compressor Cascades with Boundary Layer Suction (BLS)

Flow Control of Annular Compressor Cascade by Synthetic Jets

Control of Vortex Shedding from Two Side-by-side Cylinders Using a Pair of Tangential Jets

Study On Vortex Generators For Control Of Attached Cavitation

Separation flow control and engineering application of synthetic jets in compressor

Experimental study on the effect of fluidic oscillator jet position on the performance of a high speed compressor cascade