Abstract:Under the influence of a strong adverse pressure gradient, secondary flow, and other factors, compressor cascades are prone to corner separation and even to corner stall, which seriously affects aerodynamic performance. In this paper, large eddy simulation is used to investigate the effects and mechanisms of corner stall controlled by the blended blade and end wall (BBEW) technique. Based on this technique, three BBEW control schemes with different chord-direction positions of the maximum BBEW width are designed for the suction side root of a modified NACA (National Advisory Committee for Aeronautics) 65 blade. The influence of the chord-direction position of the maximum BBEW width on control corner stall and the differences of physical mechanisms are deeply explored. The numerical results show that the BBEW technique can improve the flow field structure and aerodynamic performance of a compressor cascade under corner stall conditions to a certain extent. When the maximum BBEW width is located near the leading edge, it provides the most significant reduction in the spanwise height of corner separation and effectively weakens the intersection of boundary layers, so that the boundary layer losses are reduced by 6.27%, and the overall performance is improved. These effects can be attributed to the axial and spanwise forces generated near the maximum BBEW width, with the former increasing the kinetic energy of the surrounding fluid, while the latter transports low-energy fluid upward to reduce accumulation on the end wall. In addition, the increased dihedral angle weakens the intersection of boundary layers and restrains the development of the corner vortex, which is also one of the underlying physical mechanisms. When the maximum BBEW width is located in the middle of the chord, it most effectively delays the corner stall. When it is located near the trailing edge, it is most effective at controlling the development of corner separation, reducing the accumulation of low-energy fluid in the three-dimensional corner region, and reducing corner separation losses by 4.73%. The effect of the increased dihedral angle in weakening the intersection of boundary layers and the corner vortex is the main reason why these two design schemes can improve the aerodynamic performance of the compressor cascade.

Effect of a blade end slot on supersonic compressor cascade hub-corner separation

Investigation of the controlling mechanisms of blade slotting technology on the shock-wave-induced corner separation

Numerical Simulation of Effect of Blade End Slot on Performance of Compressor Cascade

Effect investigation of single-slotted and double-slotted configurations on the corner separation and aerodynamic performance in a high-load compressor cascade

Experimental and Numerical Investigation on the Aerodynamic Performance of a Compressor Cascade Using Blended Blade and End Wall

Vortex structure control based bleed in axial compressor cascade with tip clearance using large eddy simulation

An Investigation on Separation Configurations in Compressor Cascades with Boundary Layer Suction (BLS)

Combined Control Method and Mechanism Analysis for Corner Separation in a Compressor Cascade

Experimental and Numerical Research on Blended Blade and End Wall Technique in a Compressor Cascade

Corner Stall Control in Linear Compressor Cascade by Blended Blade and Endwall Technique Based on Large Eddy Simulation

Full blended blade and endwall design of a compressor cascade

Experimental study on multi-angle pulsed jet actuators for controlling corner separation flow in a compressor cascade

Experimental investigations of dominant unsteady surface pressure in the corner separation region of a high-subsonic compressor cascade

Experimental and numerical investigation of two blended blade and endwall configurations

Investigation on Influence of Width and Position on Performance of Blended Blade and End Wall Cascade

Numerical Study of the Effect of Secondary Vortex on Three-Dimensional Corner Separation in a Compressor Cascade

Control and Entropy Analysis of Corner Flow Separation in a Compressor Cascade Using Streamwise Grooves.

Large Eddy Simulation and Combined Control of Corner Separation in a Compressor Cascade

Investigation on corner stall prediction and flow control by blended blade and end wall technology in a compressor cascade based on modified Spalart-Allmaras model

Numerical Study on the Corner Separation Control for a Compressor Cascade via Bionic Herringbone Riblets

Study on the Influence of Different Slot Sizes on the Flow Field of Transonic Compressor Rotors